Hall IC Placement (Support with PWB Carrier)

Subscribe to Thread

Presently, we have one PWBA with Hall IC which required desi... - Mar 05, 2003 by OnBoard Forums

Hello Joseph, I'm sure there is an alternative but I need to... - Mar 05, 2003 by CeTaQ-Sivigny OnBoard Forums

Hello sir, The component is for surface mount reflow.It w... - Mar 05, 2003 by

Hello Joseph, I'll be honest, I'm finding it a bit difficult... - Mar 06, 2003 by CeTaQ-Sivigny OnBoard Forums

Joseph

#23657

Hall IC Placement (Support with PWB Carrier) | 5 March, 2003

Presently, we have one PWBA with Hall IC which required designated PWE-Carrier to hold this component from bottom. This IC only has 4 leads at one at one side, whereas no lead available at the opposite. See below diagram for detail. _____ Pin1 --| | Pin2 --| | Pin3 --| | Pin4 --|_____| Hall IC Lead Configuration

This component is sitted in the PWB slot; hence, it required a PWB-carrier to support underneath.

Question:-

Is there any alternative of running this IC without using the PWB Carrier?

This message was posted the OnBoard Forums

reply »

CeTaQ-Sivigny

#23665

Hall IC Placement (Support with PWB Carrier) | 5 March, 2003

Hello Joseph, I'm sure there is an alternative but I need to have more information in order to make a suggestion. Is the part setup for selective soldering, through-hole for wave or surface mount for reflow? Let me know if you require additional assistance. Thanks!

This message was posted the OnBoard Forums

reply »

JOSEPH

#23679

Hall IC Placement (Support with PWB Carrier) | 5 March, 2003

Hello sir,

The component is for surface mount reflow.It would dropped into the pwb slot during component placement if no support from underneath .

RDGS

reply »

CeTaQ-Sivigny

#23683

Hall IC Placement (Support with PWB Carrier) | 6 March, 2003

Hello Joseph, I'll be honest, I'm finding it a bit difficult to understand and visualize the complete scenario. If this component is designed for surface mount placement into a slot on a PCB, then why does it even need support from the bottom side? Is it being placed on a flex circuit therefore requiring the extra support? If you'd like to call me at 603-883-7843, maybe it could be easier to diagnose what's really happening here.

This message was posted the OnBoard Forums

reply »