Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.

Rework station



Rework station | 10 March, 2004

I need to purchase a rework tool mainly for QFP's including 30mm x 30mm. I was looking at a Metcal QX2 and a Pace TF200. I would welcome any comments on these two products or any other suggestions. Also, is a preheater necessary?

reply »



Rework station | 11 March, 2004

The Metcal will run you around $5,000.00. The Pace is over $6,000.00. Check out Hakko model 852/853 for under $2,000.00

If your in the NewEngland area call us we sell them also.

reply »

Software for SMT

 Reflow System