FCM I - II Software

Subscribe to Thread

Hello, We used FujiCAM to prepare FCM programs but now we... - Sep 09, 2004 by SVI

Try Tecnomatix, Aegis and maybe Valor. They all (say they) h... - Sep 14, 2004 by

Hi, Try Technomatix. That is the one used by Assembleon i... - Sep 24, 2004 by Vinit

SVI

#30444

FCM I - II Software | 9 September, 2004

Hello,

We used FujiCAM to prepare FCM programs but now we're thinking to change it to an other software. We have some FCM and some (more) FUJI machines also. We used FujiCAM to controll and proram the lines but we changed it to Fuji FlexA. Microsoft stopped the support of Windows NT4, and unicam's FCM interface for FujiCAM is not working under 2k or XP. We're looking for a good software for FCM programming that can run under 2k or XP... and it has a good line balance function. Please recommend me some good softwares, we tried Exaline in other company sides but maybe there is some better software... Please let me know...

Thnaks. SVI

reply »

Base

#30493

FCM I - II Software | 14 September, 2004

Try Tecnomatix, Aegis and maybe Valor. They all (say they) have interfaces to the equipment vendor's optimizers.

reply »

Vinit

#30687

FCM I - II Software | 24 September, 2004

Hi,

Try Technomatix. That is the one used by Assembleon itself for the FCMs. You can buy the license from them for Assembleon FCMs as well as FUJI machines.

The Assembleon PPS designed around Technomatix, gives a very very accurate cycle time calculation after optimization.

Regards Vinit

reply »