Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Fuji cp6 nozzle repair

#35213

Fuji cp6 nozzle repair | 28 June, 2005

I am in the process of searching for anyone that does repair on fuji cp6 nozzles .7 & 1.0 mainly, We have an abundance of bent and broken nozzles that I would like to get repaired rather than throwing out so if anyone has information on this please contact me @ mjennings@telco1.com thank you

reply »

dougs

#35217

Fuji cp6 nozzle repair | 29 June, 2005

We used to use a company in the uk that did this, we stopped as the results were never that good, i think the company stopped offering the service as well as no-one else wanted to have their nozzles repaired, it's best to get new nozzles in and make sure the machine is set-up well to prevent high levels of damage to the nozzles.

reply »

#35219

Fuji cp6 nozzle repair | 29 June, 2005

I'm confused. Aren't Fuji nozzles like $20 each? Why bother? I would hope you understand that a nozzle not properly repaired could cause $50 worth of rework in about a minute after you installed it. Stepping over dimes to pick up pennies comes to mind.

reply »

#35223

Fuji cp6 nozzle repair | 29 June, 2005

Try http://www.smtresearch.com/

But the price is not much cheaper than new ones.

reply »

#35240

Fuji cp6 nozzle repair | 29 June, 2005

I found a place that exchanges old nozzles for new ones; thanks for the inputs though.

reply »

Stefan

#35249

Fuji cp6 nozzle repair | 30 June, 2005

SMT Machines china

One stop service for all SMT and PCB needs