Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Using Glue on Stencils What aperatures to use?

Views: 1938

james

#36684

Using Glue on Stencils What aperatures to use? | 16 September, 2005

We current use glue on our bottom side boards using stencils and screen printers. Our Glue aperatures that we use are very small rectangles and they seem to clog very easily. We currently are using Heraeus PD955PR #8 and see alot of boards that are not getting alot of glue because they are clogged. Any suggestions are welcome.

reply »

Mark

#36686

Using Glue on Stencils What aperatures to use? | 16 September, 2005

Call and talk to stencil manufacturer they will answer that question for you easily.

reply »

#36691

Using Glue on Stencils What aperatures to use? | 16 September, 2005

James,

Get Heraeus's input as well. They should have the best answer for their glue.

Jerry

reply »

lloyd

#36700

Using Glue on Stencils What aperatures to use? | 19 September, 2005

I had a similar problem a few years ago when glue printing. Our production environment wasn't to clean room standards and there was a bit of air born contamination floating around which would gather on the PCB surface (also our rough board edges would file off small bits of our PCB storage magazines). This was reduced by putting and Air Knife between the board loader and the printer. This blew off any dust particles or contamination which had a tendency to stick to the underside of the screen. I helped greatly but we still had occurrences.

reply »

ICT Total SMT line Provider

SMT fluid dispensing