SMT Feeder verification

Subscribe to Thread

Anyone using or know of a company with a program to verify ... - Mar 10, 2000 by

Stuart, Quad Systems had something like that a few years a... - Mar 10, 2000 by D Scott

Stuart, Pathway Sales Group 408) 779-0358 Hal Hendrickson ... - Mar 10, 2000 by NickMata

If an operator loaded a wrong value of component with the ... - Mar 13, 2000 by Dreamsniper

Cim system is what we used on cp6 d axis tables.It worked v... - Mar 20, 2000 by

Stuart Scholz

#1620

SMT Feeder verification | 10 March, 2000

Anyone using or know of a company with a program to verify SMT feeder set-up?

reply »

D Scott

#1621

Re: SMT Feeder verification | 10 March, 2000

Stuart,

Quad Systems had something like that a few years ago with "Smart Feeders". I do not know how reliable it is or was, but it might be a starting point.

reply »

NickMata

#1622

Re: SMT Feeder verification | 10 March, 2000

Stuart, Pathway Sales Group 408) 779-0358 Hal Hendrickson

Also SurPass Technologies Limited Declan Kennedy 353 91 773274 declan.kennedy@Surpass-tech.com

Hope this helps

reply »

Dreamsniper

#1623

Re: SMT Feeder verification | 13 March, 2000

If an operator loaded a wrong value of component with the same packaging, say 0805, on a feeder slot. how will the program verify this situation? or an operator interchanged 2 0805 capacitors with different values from feeder slot #5 and feeder slot #6...How will this program verify this wrong feeder set-up? Presently, we do the verification manually. after loading the feeders we verify them with our feeder lists...

reply »

RJJOHNSON

#1624

Re: SMT Feeder verification | 20 March, 2000

Cim system is what we used on cp6 d axis tables.It worked very well.I liked it and it was for pre run and during run feeder feeding.Uses a barcode reader and reads bottom of d axis where barcode are to match what is assigned to a slot by pre scanning locations and it will cycle stop fuji if conflict occurs.

reply »