GfKOOR Series | Seminar Application and Utilisation of Protective Coatings for Electronic Assemblies

GfKOOR Series | Seminar Application and Utilisation of Protective Coatings for Electronic Assemblies

 10/15/2024 to 10/17/2024

When: Tuesday, October 15
10:00 AM

Where: Virtual Event
Germany

Contact:SMTA HQ
kat@smta.org
+1 952-920-7682

*Please Note: This event is a three part seminar. Attendees may register for all three seminars or choose to register for individual seminars. 

Seminar | Application and Utilisation of Protective Coatings for Electronic Assemblies

View the full event flyer featuring key event information here! 

 15.10.2024Selection of the Coating Process 

16.10.2024Practice of the Coating Process 

17.10.2024Quality Assurance During the Coating Process

An electronic module is only suitable for a specific purpose if it guarantees safe function for a defined time. A large number of modules are installed in the terminal devices without protective coatings and operate fault-free throughout their entire service life. In an increasing number of cases, the module is used with greater electrical sensitivity or even under difficult conditions. The safe function of an assembly is then only ensured by means of a protective coating.

In the German-speaking area, there is only the GfKORR guideline for the application and properties of a protective coating available. The GfKORR working group "Corrosion protection in electronics and micro engineering" produced this guideline in cooperation of designers, producers, coaters and users of electronic construction groups. The GfKORR – Gesellschaft für Korrosionsschutz e.V. (German Society for Corrosion Protection) is an interdisciplinary association of experts from industry and R&D, aiming at reducing corrosion and consequential damages in all areas of life and technology.

The aim of the seminar, which is divided into three independently bookable training days, is to teach the participants about this guideline and the collected knowledge from the working group, so that a comprehensive and fundamental understanding of coatings and their possible applications for the functionality of electronic assemblies is achieved.

---

Registration 

Registration deadline:   10 October 2024

Please register using the green "register" button above. Following receipt of the registration, a confirmation and the invoice on the amount due will be sent to the course participant.

 Members of GfKORR 450,- €

 Non-Members  490,- €

Students (Under 30)  90,- €

Following receipt of the registration a confirmation and the invoice on the amount due will be sent to the course participant. Registered participants can cancel in writing free of charge no later than 10 October 2023. After this date 80% of the participation fee will be charged. In case of absence or cancellation of participation, the full participation fee is to be paid. A replacement of a participant is always possible.

No VAT requested according to § 4.22 UStG
The registration fees include the guidelines for the Utilisation and Fabrication of Protective Coatings for Electronic Assemblies.