Electronics Forum | Thu May 10 09:57:22 EDT 2001 | zam_bri
Hi Cal/Dave F, Good news today. The problem went away when I received and ran with a brand new component today. But I'm sure with a robust profile, I should be able to compensate oxidations at some degrees, rite? ( taking into consideration the suc
Electronics Forum | Wed May 09 15:15:52 EDT 2001 | caldon
Your process needs some refining. How long did it take to wet? How much force did it take to break the surface tension? What type of solder was in the solder pot? What type of flux was used? What was the pot temperature? Did you take a cap and p
Technical Library | 2023-01-17 17:27:13.0
Reflow profile has significant impact on solder joint performance because it influences wetting and microstructure of the solder joint. The degree of wetting, the microstructure (in particular the intermetallic layer), and the inherent strength of the solder all factor into the reliability of the solder joint. This paper presents experimental results on the effect of reflow profile on both 63%Sn 37%Pb (SnPb) and 96.5%Sn 3.0%Ag 0.5%Cu (SAC 305) solder joint shear force. Specifically, the effect of the reflow peak temperature and time above solder liquidus temperature are studied. Nine reflow profiles for SAC 305 and nine reflow profiles for SnPb have been developed with three levels of peak temperature (230 o C, 240 o C, and 250 o C for SAC 305; and 195 o C, 205 o C, and 215 o C for SnPb) and three levels of time above solder liquidus temperature (30 sec., 60 sec., and 90 sec.). The shear force data of four different sizes of chip resistors (1206, 0805, 0603, and 0402) are compared across the different profiles. The shear force of the resistors is measured at time 0 (right after assembly). The fracture surfaces have been studied using a scanning electron microscopy (SEM) with energy dispersive spectroscopy (EDS)
Mx400L has an IPC 9850 speed of 42,000 CPH. It will accomodate a PCB size up to 26.77" x 18.11", it has 6 module heads on the front gantry, 6 module heads on the rear gantry. minimum lead pitch is 15mil, and it will place parts down to 01005 (0402 me
Evaluation of Laminates in Pb-free HASL Process and Pb-free Assembly Environment SMTnet Express September 20, 2012, Subscribers: 25503, Members: Companies: 8989, Users: 33687 Evaluation of Laminates in Pb-free HASL Process and Pb-free Assembly
| https://www.feedersupplier.com/sale-13118498-fuji-nxt-m3ii-320mm-module-width-smt-chip-mounter.html
FUJI NXT M3II 320mm Module Width SMT Chip Mounter Leave a Message We will call you back soon! Your message must be between 20-3,000 characters
Lewis & Clark | https://www.lewis-clark.com/product-tag/chip-shooter/page/2/
Chip shooter Archives - Page 2 of 2 - Lewis and Clark Skip to content My Cart: $ 0.00 0 View Cart Checkout No products in the cart. Subtotal
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
.gif)
