New Equipment | Rework & Repair Equipment
BEST HeatShield Gel™ is a thermal shield water-based gel designed to be used in the PCB rework/repair or board assembly areas in order to provide thermal protection of electronic components. It is truly a revolutionary means to protect components. It
New Equipment | Solder Paste Stencils
Eliminate hours of solder mask damage repair time for bga sites while improving rework yield. Are you frustrated by the time it takes to repair mask damage underneath the BGA during the rework process? Are you squeezed for space on the PCB in an
New Equipment | Cleaning Equipment
CM11 , CM 22, CM33. CM60 – Ionic Contamination and Cleanliness Test Systems to MIL & DEF standards.
New Equipment | Test Equipment
Fast and accurate ionic contamination cleanliness testing. Dynamic testing of ionic contamination is a widely approved and followed standard. So, too, is the equipment that makes it possible - SCS Ionograph®. Available in different models, the SCS
New Equipment | Test Equipment
PROCESS SCIENCES, INC. (PSI) Visit our main Ion Chromatography page for more information. Ion Chromatography analysis (IC) is an essential tool for both failure analysis and process validation. PSI uses IC to investigate surface contamination and m
New Equipment | Cleaning Equipment
World’s First Cleaner & ROSE Tester Removes Fluxes Performs IPC ROSE Test Closed Loop Operation - No Drains Aqueous or Organic Solvents Stainless Steel Construction Automatic Wash/Rinse/Test/Dry 230VAC, 10AMP, 50/60Hz
Lite Fast 2081, a UV encapsulant, was specifically developed to relieve the stress placed on toroidal coils or electronic components that will experience pressure during the molding process. With a durometer Shore D hardness of 5, the UV encapsulant
New Equipment | Cleaning Equipment
SOLVENT IONIC REGENERATION Increases bath life by removing flux as well as particulate contamination from the wash solution. This provides on average a 300% to 1000% increase in bath life and reduces solvent waste. Ionic regeneration also increases
New Equipment | Cleaning Equipment
Zero Ion Ionic Contamination Tester Today's Zero Ion is designed to meet the cleanliness testing challenges associated with modern circuit assemblies. The Zero Ion is capable of extracting and quantifying assembly contamination levels per IPC J STD0
For heat dissipation Conventional methods measure an adhesive's bulk conductivity, in watts/m-°K. However, across a thin bondline, the resistance of the adhesive itself is only a fraction of the total resistance. Interfacial resistance is a signifi
.gif)
.gif)
