Electronics Forum | Mon Oct 09 15:15:57 EDT 2023 | ushir
Good Day Please could someone assist with a copy of the Fastpath software for PVA 650 Conformal Coating machine. I have a copy of Pathmaster 4.0 should anyone require it. Thans
Electronics Forum | Mon Sep 27 20:40:05 EDT 2004 | danhui888
Hi, You may look into PVA 650 which cost around US$40K for a unit. Let me know which company you are or which location will you be and I shall get my team to visit you and let you know more about this sysytem. Regards Danny Hui
Electronics Forum | Thu Jan 22 09:04:22 EST 2009 | mefloump
Humiseal recommends a 1 to 1 mix ratio of 1B31 and Thinner 521. I have for that I need to thin my ratio more to get humiseal to spray correctly in our PVA650. Also I am using Humiseal 1B73 but the tech data sheets say the same for spraying. Try thinn
Electronics Forum | Thu Jan 22 08:51:07 EST 2009 | mefloump
We use green painters masking tape. Comes off easy and doesn't leave a residue. The blue colored masking tape works well also but tears too easily. Ours runs through and IR oven to cure the coating after it runs in our PVA650 and we have not seen and
Electronics Forum | Thu Sep 10 15:01:28 EDT 2009 | mefloump
I currently spray DOW 2620 with my PVA650 without any problems. I do not thin it but I do have a distance between the coating machine and IR oven to provide a flash off period. I notice bubbles only when the flash off time is too short and the coatin
Electronics Forum | Wed Oct 26 08:26:07 EDT 2011 | edmaya33
Anybody here with extensive knowledge with PVA650/2400SF coating robot? I wanted to know the semi perfect settings for my FCS-300 valves. Anybody can share their thoughts. Tank Pressure: Atomized Pressure: Path Speed: Path Distance: Height: Valve op
Electronics Forum | Tue Nov 01 09:16:03 EDT 2011 | austinpeterman
Hello, Looking for a solution to silicon conformal coating wicking up into connectors. We build IPC-A-610 class 2. We are using a PVA 650 with Dow Corning 1-2577 conformal coating. We have solder joints that must be coated 1.25mm from the connecto
Electronics Forum | Tue Feb 19 08:08:29 EST 2013 | williamaxler
My company is starting to look into Conformal Coating Equipment. From preliminary talks it sounds like we would like to use a UV material. I have a few question I was hoping as a group you all would be able to pass along some insight. 1. Do any of
Electronics Forum | Wed Feb 20 10:12:27 EST 2013 | dontfeedphils
Hey Bill, it really depends on the material you're looking at using UR, SR, AR, the easiest to deal with being AR, although if you can find a UR that doesn't clog up the machine too bad those are usually more viscous and easier to apply selectively u
Electronics Forum | Thu Dec 26 12:12:55 EST 2013 | igorfo
Dear Friends, I need your help to understand requirements and measurement methods for bow and twist of assembled PCB (PCBA have and SMT and TH components). I already check all posts on the site but didn't found any related to my question answers.
.gif)
winsouce.jpg)