Electronics Forum | Fri Mar 26 23:07:07 EDT 2010 | dekhead
Just a guess: Are you printing your fiducials on the fiducial side of the board? Fidicial Side is for Vision Calibration, Bare Copper Side is for Offset Calibration (Step 5 of procedure says "copper side uppermost"). After printing 25 fiducials o
Electronics Forum | Fri Jan 31 11:45:52 EST 2014 | emeto
Hi, to get better image you will probably need higher voltage(depending on how close you want to look). The closer you get the higher the voltage should be. Here are some tips for machine calibration: 1. Make sure your board is on focus. I don't kn
Electronics Forum | Sat Jun 05 08:18:03 EDT 2004 | vinitverma
Hi Grant, If you're really looking for speed, I'm sure you're looking for another machine for doing the QFPs, BGAs stuff etc. In that even, why not have a look at the long proven Assembleon FCM machine!! It is a totally different concept with UNMATC
Electronics Forum | Wed Feb 05 08:51:13 EST 2014 | emeto
What I think it does is to calibrate the camera. You have your tube on the bottom and your camera on the top. For my machine(Dage) I have to put the board I am going to examine inside and select a point on the board surface. THen I just click on this
| 1 |
winsouce.jpg)