Electronics Forum | Thu Mar 15 21:57:41 EDT 2012 | daniel26
On your mount data it has to go 8,7,6,5,4,3,2,1 once it goes to a higher number then the previous it has place and start over try that out
Electronics Forum | Tue Jul 02 10:57:29 EDT 2019 | BigFuji642
Are the pinouts for the cable mirrored (like normal Male to Female DB pinouts)? Like the Male pins when looking straight at them are 1 2 3 4 5 and the female when looking straight at it is 5 4 3 2 1 Or is it that they are not mirrored and both ar
Electronics Forum | Tue Jan 18 08:40:42 EST 2000 | Dave F
Hey John: Chrys wrote a good description on calculating flux density a while back. Here is our version of her procedure: 4.3 Determine the amount of flux on the board. 4.3.1 Get a piece of corrugated cardboard and a weighing scale accurate to 0.01
Electronics Forum | Tue Jan 05 18:07:53 EST 1999 | Dave F
| I am looking for information regarding post wave soldering of stranded wires into a circuit board using OA core wire solder. We do a final pass thru the cleaner after the hand soldering but I'm concerned about any OA flux residue that may have wic
Electronics Forum | Tue Nov 03 16:28:21 EST 1998 | Dave F
| Well my process is I'm running my belt speed at 3.50fpm and about 215 to 225 degrees top side. I got my main wave down to a little less than half the board thickness. I'm not using a hot air knife cause we thought it might create more of a problem
Electronics Forum | Mon May 07 11:09:49 EDT 2007 | davef
4 Fluxer Operation 4.1 Set-Up and Check-Out the Fluxer 4.1.1 Spray Fluxer Set-Up and Check-Out 4.1.1.1 Pass a sample unsoldered board through the machine. 4.1.1.2 Remove the board just after passing through the fluxer and the air knife. 4.1.1.3
Electronics Forum | Fri Jan 28 12:18:32 EST 2005 | Chunks
Your best bet is to do a decision making matrix. Each company has so many different criteria�s it's hard to pick out which one might be important to yours. Simply pick out your top 5 paste manufactures. Next decide what your "Eliminators" are - th
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
| 1 |
.gif)
winsouce.jpg)