Electronics Forum | Fri Mar 11 04:12:28 EST 2016 | grahamcooper22
Please can any users of the Rheopump or Enclosed Print Head unit tell me what cartridge pressure setting they use when using lead free paste....many thanks Graham
Electronics Forum | Fri May 23 04:25:14 EDT 2008 | muarty
One thing that has to be considered when using rheometric pumps is that the board support should match as that of the pump head being used. You can print 6" boards, but you should really still use board supports upto 16". As mentioned previously if t
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Wed Aug 26 18:36:17 EDT 2020 | serge_pirog
Hello. Could I ask you for help. We have DEK Europa. We have changed ProFlow to squeegee head with feedback. After this during solder paste printing system shows the difference between set pressure (9 kg) and real pressure (7,5kg). I have read manual
Electronics Forum | Thu Dec 18 21:36:03 EST 2003 | pdeuel
Blade angle, print speed, squeegee pressure, should be used in conjenction with one another. The more parellel the blade is to the stencel the more it will tend to float over the solder and the more paste is forced thru the appature. Contrary the gre
Electronics Forum | Fri Sep 21 17:35:46 EDT 2007 | valuems
the answer is very simple, it comes from 12 years of experience on the mpm's. And once you've done a calibration on the programmable print head, on a AP model you will know what I mean when I say it is not the easiest thing to do. harry
Electronics Forum | Thu Feb 17 17:33:34 EST 2022 | mnorthey
Hi all, I have a Dek 265 Horizon that fails to print at the correct pressure. It fails pressure every pass. I am trying to Calibrate it with a PFR1200N pressure Tester which we use for our DEK 248 Printers. I am trying to build up the table height
Electronics Forum | Thu Aug 12 22:31:10 EDT 1999 | Dave F
| Hello, | | Can any netters suggest what critical parameters should be considered & what are there assoicated impacts for a solder paste printing process ... | | B.Regards, | Felix | Felix: There are some 30 variables that affect SMT solder qua
Electronics Forum | Thu Feb 14 17:36:28 EST 2013 | dontfeedphils
I'm trying to get an '07 Accuflex into production and I seem to have a small problem. When trying to calibrate the zero pressure point on the squeegees I drive them down until they are touching the stencil and once they touch the stencil they run ou
Electronics Forum | Fri Mar 18 15:02:07 EST 2005 | pmd
Please clarify, Z axis gears (Blades)? The MPM head I believe is what your are asking is driven up and down via a lead screw. The machine gets the zero point from the "HAT" tactile sensor in the table nest. When squegees are installed the blades are
.gif)