Electronics Forum | Thu Sep 19 21:46:01 EDT 2002 | scottefiske
In the past year I was responsible for developing and leading a Team focused on AOI, Evaluation, Justification, and with a full ROI required, supporting a HMLV manufacturing environment. If you have in these economic times the additional resources t
Electronics Forum | Tue Aug 21 21:11:29 EDT 2001 | davef
It depends on what you're doing. Say for component placement verification, a line that's kicking-butt might have time to look at a somewhat different quarter of each board, depending on lots of stuff [eg, board, AOI equipment, line rate, etc.]
Electronics Forum | Wed Aug 22 12:39:58 EDT 2001 | andyy
From the manufacturer's perspective, we aim to be able to fully inspect all components within the beat rate of the line and generally do. I'm not aware of any competitive machines that do the random sampling that is suggested above, however it is do
Electronics Forum | Thu Nov 01 09:23:27 EDT 2007 | pjc
If you are in the Americas, I'd contact tech support and they should square you away on that high false call rate problem. They have great WebEx training and troubleshooting. www.mirtecusa.com
Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
Electronics Forum | Wed Jun 19 14:40:58 EDT 2024 | davidk
Hello Carl, Thank you for your comment Obviously, we are evolving and debugging our test to get the best results ("no escapes no false calls") :) and using a combination of 3D and 2D tests. With the previous AOI, we had a much higher false call rate,
Electronics Forum | Thu Aug 07 22:56:50 EDT 2008 | dlocampo
First all, you must define the specific defects that you wanted to screen out by your AOI system based on its capability, so you can allocate the undetected defects on your other means of inspection methodology. Then optimize your AOI inspection para
Electronics Forum | Wed Jun 19 15:28:58 EDT 2024 | davidk
Hi Tom, Thank you for your comment 75% FPY is also our target, cause we gonna have the AOIs in the SMT line. So you would expect more opportunities? I didn´t notice but there are not so many components with high opportunity rate. (the average numbe
Electronics Forum | Thu Jun 13 08:10:51 EDT 2024 | carl_p
You would need to be more specific on the AOI in question here. 2D, 3D features will also have a big impact. Are you constantly evolving or updating the models to improve the situation or going from just the base program as if low volume it can be a
Electronics Forum | Tue Jun 29 11:46:36 EDT 2010 | davef
Prins: Everyone has equations. Here's one some people use: False call rate = [Number of defective boards, but good at inspection]/[Total number of boards produced] Why don't you ask the people [that calculated the numbers that confuse you] how the
