Electronics Forum | Tue Jul 02 15:28:37 EDT 2024 | mirkospada
Hi, we have an used ASSCON VP450. But tghe time in - out of the PCB is about 25 minutes. Very high time. The most long time is in pre-heating fase. EDR=100% Have you any ideas to configure it? Thank you
Electronics Forum | Fri Nov 19 13:46:14 EST 2004 | Dreamsniper
I used ASSCON VP450 with Galden 205 Fluid. It worked fine. Good Solder Joint Quality. I'm not promoting the product just sharing what I had.
Electronics Forum | Fri Apr 30 15:51:06 EDT 2010 | ldavis
We are using an Asscon VP800 with Galden LS230 fluid. This is a batch machine but is working well in our high mix-low volume environment.
Electronics Forum | Mon Aug 12 15:56:13 EDT 2013 | pjchonis
Vapor phase soldering systems by Asscon are characterized by special designed heating modules. The thermal mass of the heating modules is designed so that a completely delay-less and direct regulation of the heat/flow/energy transfer to the soldering
Electronics Forum | Wed May 12 11:55:08 EDT 2010 | pbarton
We are using VPS, but only for high mass assemblies. As the other respondent has suggested if the mass of the assemblies is very low then difficult to control temp. rise times to within the normally accepted parameters. The Rehm equipment does seem
Electronics Forum | Fri Apr 05 22:01:03 EST 2002 | MikeK
We are looking at getting a new inline SMT reflow oven and I have been shown a new vapour phase oven made by ASSCON. It looks very good - just want to know if any one has used one before and can comment. Thanks
Electronics Forum | Thu May 23 04:56:12 EDT 2024 | wippsen
may i ask wich password do you use?
Electronics Forum | Tue May 21 12:57:46 EDT 2024 | mirkospada
Hi, we have a ASSCON VP3000 vapour Phase oven. The touch screen of the display don't work. We have try to use VNC VIEWER to command it, but we can access, we see the display on the pc but no way to control. What can we do? Thank you
Electronics Forum | Thu May 23 11:36:50 EDT 2024 | wippsen
As I mentioned before, you probably have view only access set up. create a completely new VNC shortcut. Do not use existing shortcuts. Connect to the machine's IP address and use "r" or "c" as the password.
Electronics Forum | Wed May 22 10:38:53 EDT 2024 | mirkospada
Hi, Yes, but when I do the access it exit on error. When I use VNC VIEWER not server, I don't know how insert the passcode
