Electronics Forum | Fri Jun 15 12:07:13 EDT 2018 | fern
My company is hooking up a delta max wave solder machine but we can seem to get the estop error to go away any one have a any experience with this issue.
Electronics Forum | Thu Jun 28 14:45:55 EDT 2018 | aksaustin
What error is it throwing?
Electronics Forum | Thu Jun 28 18:50:08 EDT 2018 | caurbach
We don't have your exact machine or know your exact configuration, but our machine has occasionally gotten an estop due to a breaker in the SelectX tripping. Just be aware that there are circuits other than the mushroom switches that can generate an
Electronics Forum | Wed Oct 24 21:17:13 EDT 2007 | hussman
Ramp rate is measured in degrees per second. Max and min temps are not required to to establish "ramp rate". The difference between parts, like I was describing is Delta T. But, ramp rate is a generation from this as well. Most component manufact
Electronics Forum | Wed May 19 07:38:42 EDT 2004 | Bob L.
I'm trying to help one of our remote sites solve a problem with a warped PBGA. The corners are lifted, creating columnar joints and the central balls are sometimes shorting. I've verified that it's not popcorning and I've got samples going to the l
Electronics Forum | Mon May 21 17:56:04 EDT 2007 | mefloump
We have a Delta Max (leaded) and a delta wave (lead free) and a soltec Selective solder. The software that runs the selective solder is much different than that of the wave machines. We have fitted our selective with a leaded and lead free pot to han
Electronics Forum | Wed Sep 20 17:06:23 EDT 2000 | jackofalltrades
On the Vitronics/Soltec Wave Soldering Machines, we have no problems with the hot air knife (called a "Select X De-Bridging Tool" by Vitronics). We have both Delta's and Delta Max's. We have used both air and nitrogen with no problems. When using a "
Electronics Forum | Fri Mar 10 12:15:52 EST 2006 | geocominc
Increase Soak time & Slow down line did reduced Delta T by 10+,Fans are at max - Both High -getting closer to target now.Great idea.still more to do .Thanks for advices.
Electronics Forum | Thu Mar 09 15:04:41 EST 2006 | geocominc
Please advice how can we reduce a delta T of 40 degres between pads with a seven zones reflow for a LF Assy. max 255 min 215 board size 3x5 inches.
Electronics Forum | Mon May 20 19:24:59 EDT 2013 | hegemon
Well, you wouldn't want 100 deg difference from zone to zone, in that you would likely exceed your maximum ramp rate, for instance if Zone 1 was 90C and zone 2 was 190C. Over time a general guideline (rule of thumb) has emerged, max about 40 deg dif
.gif)
