Electronics Forum | Wed Jan 17 21:02:48 EST 2007 | Jnet
If you are just wanting a replacement blower for your air crossflow cooling section. You should be able to purchase through Electrovert cheaper than $1600 dollars. Someone must have quoted you more than just a replacement blower.
Electronics Forum | Mon May 20 15:25:13 EDT 2013 | smtventasmex
Hi i can help you with your blowers needs contact me at vhmaderoATsmtvys.com
Electronics Forum | Tue May 07 09:26:38 EDT 2013 | emeto
Hello knowledgeable people, we have Omniflow 10Zone oven from 3-4 years and we changed over 20 blowers. The blower is German and I think is a very good quality(quite expensive too), but still keep getting bad. Does anyone have similar problem? Do yo
Electronics Forum | Wed May 22 12:59:09 EDT 2013 | cyber_wolf
That sounds very odd what smter is saying. The screws around the outside of the fans have nothing to do with the bearings. You only really need to tighten those screws enough to squish the gasket a little. No special torque settings required. As lon
Electronics Forum | Tue May 07 09:42:17 EDT 2013 | cyber_wolf
We bought a "very used" Omniflow 10 at least ten years ago. We have only replaced maybe 5 blowers in that time.
Electronics Forum | Tue May 07 13:11:33 EDT 2013 | emeto
Hi Hege, there is insulation, which when you look at looks pretty stable.I suspect that there is more heat transfer through the shaft from the propeller to the motor. However when I touch the motor it is not really hot, so I am confused what really
Electronics Forum | Wed Feb 02 19:55:31 EST 2022 | dwl
you may also want to try replacing the Motor capacitor. This is often the culprit on those blower motors. I found them on Amazon for $3. much better then $450 for a new motor.
Electronics Forum | Tue Jan 11 13:29:45 EST 2022 | bmalhi
You can purchase full motor assemblies directly from Heller. Please contact service with oven serial numbers and motor location ServiceNJ@hellerindustries.com.
Electronics Forum | Thu Dec 21 11:55:31 EST 2006 | realchunks
I have one form a year 2006. Uses the studds to keep track of revolutions. Four wires going to the motor.
Electronics Forum | Fri Dec 22 11:21:50 EST 2006 | Jav Thug
pls share the photo with all. I would like to formulate a pie-chart on motor revolution
.gif)
