Electronics Forum | Mon Nov 11 02:28:27 EST 2002 | Melvin
I want to make a double-sided PCB. the process include conductive filling via for RF guarding. Does anyone can tell me where I can do it?
Electronics Forum | Thu Sep 08 09:52:37 EDT 2005 | russ
Welcome to the wonderful world of tin boards!
Electronics Forum | Thu Sep 08 06:19:55 EDT 2005 | lupo
Hello, Could anyone provide some support concern issue with vertical fill of through hole solder. Our lead free wave soldering process is not capable to fill 100% (requirement of our customer)through hole. We made everything (DoE) - different amoun
Electronics Forum | Thu Sep 08 08:54:09 EDT 2005 | Slaine
if the problem is wetting change the flux type. have you tried adjusting the temperature of the wave? if your getting 100% wetting id decrease the wave temperature, or try a flux that is less active.
Electronics Forum | Thu Sep 08 09:47:20 EDT 2005 | lupo
I will try with temperature 255 C degrees. The wetting force vs. solder temperature for SAC305 is more than 265 C degrees (the temperature of trials). Thanks for the advise. Regards
Electronics Forum | Mon Nov 11 11:28:32 EST 2002 | davef
Sand is not a great conductor, compared to copper. Never heard of using the stuff on RF boards. Our board fabricator uses Dupont CP100, now CP101, [or something like that cuse who's going to check?] when plugging via on cheap boards. Your board fa
Electronics Forum | Wed Dec 19 09:24:21 EST 2012 | swag
Many times we manually add flux from the top side for good fill.
Electronics Forum | Wed Dec 10 00:15:07 EST 2008 | jeffjarmato
Are there any good solutions for getting good barrel fill on PTH boards using Pb Free solder and No Clean flux. All of our boards are having issues getting minimum required fill per IPC. It does not matter if the board is 062 or thicker, any pin conn
Electronics Forum | Wed Dec 19 09:41:14 EST 2012 | dyoungquist
What is your solder pot temperature? We found that on a 0.093" multilayer board increasing the temp of the lead free solder from 300C to 315C helped with the barrel fill.
Electronics Forum | Tue Dec 18 10:14:14 EST 2012 | moshesh
In those cases where we have a 3.2mm thick, 16-layer board with several GND layers, do we still need ground connection to each and every layer (with thermal relief) or, skip part of the ground patterns? Will it help soldeing rising. I can't reach mor
