Electronics Forum | Wed Jul 08 16:01:23 EDT 2015 | goodting
Hi Gentlemen/ladies: Can someone tell me where I can buy a GSM Advantis feeder loading station(for used one)? Appreciated your information. GTing
Electronics Forum | Tue Dec 19 09:55:16 EST 2006 | bsteffen
If you call up Universal tech support at 1-800-842-9732, any of those guys or gal would email you the schematics to the MPUP feeder setup station.
Electronics Forum | Tue Aug 01 06:21:37 EDT 2006 | Rob
Hi, anyone in the UK using RAMTIFFs on their GSMs? we're having a clearout and have 2 spare, free to a good home. Also got 4 GSM feeder changeover/test trolleys - free as above. Rather they went to someone who is going to use them, than some one wh
Electronics Forum | Mon Jan 29 11:53:54 EST 2007 | mika
Is this a single beam (GSM1)or a dual beam machine (GSM2)? If it is a GSM1; how does the pickup works with Head 2 from the front feeder banks? Do you have removeable or fixed feeder banks? If removeable, make it fixed, using screws through the bank
Electronics Forum | Thu Dec 15 06:20:11 EST 2005 | rlackey
Hi Liza, We've seen it occaisionally in house on Universal GSM 8,12,16mm but not on Fuji (except when a feeder's not used for a while). Also on 44, 56 & 72mm (the smaller vol parts I mentioned earlier. It tends not to affect the Hoover Davis Feeder
Electronics Forum | Thu May 03 15:02:59 EDT 2018 | solderingpro
Bob Willis (was the first I knew of) that has a splatter test that can be performed over a ceramic hot plate or the like. The concept is pretty straight forward, using a zoned circle, users can introduce the solder wire at a consistent rate and coun
Electronics Forum | Mon Jan 29 10:50:35 EST 2007 | mika
What about the component placement with Head #2? Head # 1 is ok? Is it only the pickup that is the problem and if so, from all feeder banks (front & Rear)? Concider Z-axis height adjustment, procedure is in the manual. You normally don't need to re-
Electronics Forum | Wed Apr 28 15:23:47 EDT 2021 | procyon
Hello Deni, Thanks for the comment. Could you provide a bit more information as to what pins are used to accomplish this specifically for Universal Instruments Blue label older feeders? Here is the pinout I got from UI but it does not show a statu
Electronics Forum | Thu May 10 13:53:36 EDT 2001 | stefwitt
If you get the price for the tray and holder from Siemens you will follow Dave's recommendation. To get the 0 point for the tray ( from where you measure the first pick position )you set up the tray on the 7th track ( type 51 ). After you sent the da
Electronics Forum | Fri Nov 19 07:45:59 EST 1999 | Claude Couture
Our Panasert MSH is randomly mixing up the parts placement. About 1 in 10,000 placement will be a wrong part. The wrong part may be any other part present on the feeder carriage. A chip resistor 0805 may be replaced by a minimelf or a sot-23. It is