Electronics Forum | Mon Feb 17 18:53:34 EST 2020 | richgreen01
Hi all I am experiencing z force sensor errors on a couple of different nozzles ( not hydra ) any help appreciated.
Electronics Forum | Tue Feb 18 14:37:41 EST 2020 | bk
What type of head do you have on your machine a midas head or a zi-fi head? Regardless of which you do have I would make sure that the head is clean where to tools go into the head. Use a soft swab or something similar so you do not damage the z forc
Electronics Forum | Sun Dec 17 13:52:59 EST 2023 | tomdegas
How can I bypass the " Hydra force sensor can't calibrate" during the "Hardware Initialization" test. This is stopping me from starting the machine.
Electronics Forum | Thu Dec 21 17:04:28 EST 2023 | cyber_wolf
Disable the hydra head.
Electronics Forum | Thu Dec 28 20:46:49 EST 2023 | padawanlinuxero
I was use to work with the machine but it has being several years since I had one in my hands, but i got the same error message, I kinda remember there are some sensors in the top part of the hydra try to see if theres dirt or something not letting t
Electronics Forum | Wed Apr 28 10:29:04 EDT 2004 | dougt
By "placement pressure" I assume you mean force. I don't know of placement machines that have transducers mounted on the placement spindles that actually measure force. We made a board with a force sensor mounted through a hole so that it was the sa
Electronics Forum | Wed Jan 05 11:26:15 EST 2005 | cyber_wolf
Then Z MOTOR > Then select>CALIBRATE FORCE SENSOR NOTE: you must have a tool in the head when you do this.(Without the tip/spring pushed in) After this calibration the force should drop to 0 when you push in on the spring loaded tip. 2.) Replace th
Electronics Forum | Tue Nov 14 19:59:22 EST 2006 | wchang
Heller 1800S Convection Reflow �� 1996 - 97 vintage �� Dimensions: length 150��, width 53", height 63", �� Number of forced convection zones - top 9, bottom 8 �� Cooling zones: 2 �� Conveyor width (m
Electronics Forum | Sun Aug 02 21:59:37 EDT 2009 | hohk
Wow! Thanks Jim!. When the ejector pin hits the piezo ceramic sensor, the sensor will produce a voltage difference between the top and bottom surface(that's why i need to connect the tracks on both sides) which i will measure. The sensor does not ne
Electronics Forum | Fri Oct 15 03:00:21 EDT 2004 | pierrenoir
Hello to you all I was hoping one of you guys would be good enough to give me some advice on a problem I am having with some training simulators I have developed for my work. I have basically built two electronic control simulators to duplicate the o
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
