Electronics Forum | Fri Apr 05 01:52:57 EDT 2024 | ddfreeze
Samsung SM321 machine fails to initialize when booting software. I have swapped PCI and communication boards, all resulting the same, I replaced the CMOS battery on communications board, tested the voltage on the backplane, and reloaded the software
Electronics Forum | Sun Aug 07 09:18:07 EDT 2011 | jjcarver
amplifiere error states, Amplifier setup error, programming during startup failed.. Cannot get machine to initiate anyone have this problem?? machine is a MYDATA19e
Electronics Forum | Thu Aug 14 13:49:26 EDT 2014 | dyoungquist
Motor control MSETDYN -> Initiate axis C -> Centering jaws 156 -> Motor timeout Did not reach specified position Hardware problem Looks like you have something wrong with the movement of your centering jaws.
Electronics Forum | Mon Sep 06 08:38:54 EDT 2010 | sachu_70
I am impressed to know that you are a one-man army confronting YV100Xg. However, you could always call in for an Engineer from a YAMAHA service provider to resolve your problem. Else, just try by reinstalling your machine software. But before you do
Electronics Forum | Thu Apr 28 03:58:52 EDT 2022 | erici
We are having problems with our Siemens Siplace S27 machine. The machine is giving the error - Y-axis Faulty initialization of Motor. We replaced the Y motor card and swapped also the servo control cards on the two gantries. Still will not initiali
Electronics Forum | Thu Feb 20 13:16:15 EST 2014 | rgduval
Hi, Brendan, It sure sounds like it to me. But, with the Z axis, there could be one other thing to check. On my old TP, there were z-locks...two pistons that pointed sideways around the head travel. Initializing the z-motors did not move the z-
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Sat Aug 08 09:45:11 EDT 2015 | edwaterfall01
It would be helpful to know what happened before the error occurred. Do you have another machine so that you can swap some boards? The Force CPU, (machine controller) located in the VME, is responsible for controlling all machine-related activities.
Electronics Forum | Wed Aug 12 12:02:41 EDT 2015 | edwaterfall01
I think the heart beat message comes up if the vision had not initialized. You have changed that already stop I think it is something else. Have you some money a Restore of the Machine Configuration and Mapping and Calibration Data?
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
winsouce.jpg)
.gif)
