Electronics Forum | Tue Jan 08 16:25:00 EST 2013 | eduardo3mx
hello I need your help I have a machine mpm ultraprint3000 with the damaged hard drive I made a copy to the hard drive of another machine the same, but I have problems with the x-axis origin does not, either the track center, and the stencil wiper w
Electronics Forum | Fri Jun 12 14:19:03 EDT 2015 | tdemon69
i have a up 3000 ultraflex. the lower half of the tactile sensor is stuck down. i have replaced the driver board, check wire down to drive board,check the fuse for power on the driver board.
Electronics Forum | Sat Jun 13 13:51:44 EDT 2015 | tnisbet
The problem could be the tactile motor, we have it in stock. Please contact sales@goppm.com and request a quote for part number CA-399.
Electronics Forum | Sun Feb 13 20:12:53 EST 2000 | K. S. PARK
Hello . i am reviewing the s/p dek (dek 265 infinite) ,mpm (up3000). all user say the machines are good. but to me rheopump versus proflow. which one is better. someone out there using these head advise me. bad or good thing whatever it is
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Thu Jul 02 17:06:39 EDT 2015 | aemery
Just to clarify, you are talking about the inner black box not driving down and not the pneumatic function that brings the tactile assembly closer to the stencil? Sometimes the pneumatic shafts get slightly bent and the assembly will not retract. T
Electronics Forum | Fri Aug 11 11:18:20 EDT 2006 | chrisgriffin
I got a 3000 that is acting crazy. After a print, the board is unclamped and the Z-axis lowers. It continues to lower until it trips the limit switch. It is suppposed to move in the Y-axis to line up with the tracks while lowering in the Z-axis.
Electronics Forum | Mon Aug 14 11:30:25 EDT 2006 | SWAG
We had centernest to I/O track alignment problems that were not predictable on 3000. Z-axis height seemed good with relation to I/O tracks but y was misaligned. Ended up replacing y-axis stepper and trouble went away. Also have had trouble with z-
Electronics Forum | Thu May 24 02:09:29 EDT 2007 | einat
I would like to learn more about the differences between the two. Which one do you recommend more and why? Also if someone can stand on the differences between: MPM UP 3000 HI E MPM UP 3000 MPM UP 2000 HI E MPM UP 2000 Any information would help!
Electronics Forum | Thu May 24 12:56:31 EDT 2007 | adlsmt
Im sure you will get some better responses but here is a start. We went from UP2000 to UP3000 Ultraflex about 2 years ago. The UP-2000 uses tooling nests and UP-3000 Ultraflex does not. Makes a huge difference in setup time. Up-3000 is BIG. I think t
.gif)
