Electronics Forum | Wed Sep 11 15:49:10 EDT 2002 | stepheno
Are you no clean or WS? Have you used a MultiMeter to verify the ICT failures? Maybe the components are fine but the pins are contaminated. Or the test points. Don't have any reason to suspect that due to HASL vs gold. It's just I don't trust data o
Electronics Forum | Thu Mar 15 02:25:04 EDT 2007 | Mike Konrad
Dave, I would not recommend use of a multi-meter to determine high quality DI water resistivity readings. There are a number of reasons including a multi-meter�s lack of temperature compensation. We use a Myron-L resistivity meter to accurately de
Electronics Forum | Tue Sep 01 10:55:41 EDT 2015 | emeto
Hi, 1. Take a multi meter and measure the voltage - I assume it is a DC motor(probably 24V). If you don't, check power supply,cable, relays and Driver for the motor. If you do have voltage, check sensors(sometimes sensor activated may stop your con
Electronics Forum | Wed Jan 20 08:18:20 EST 1999 | Claude Couture
The situation: When I press the "ZERO" button of the dip inserter, the x-y table moves very slowly toward the -x -y corner. If I release the button, the x-y table stops. The 36 vdc is dead. I replaced the "1REC" (it was fried) and the problem is st
Electronics Forum | Wed Sep 14 07:37:56 EDT 2016 | awhite
Thanks for the link, Ive actually always wanted to learn Italian :) Unfortunately, because this has been an issue for about 2 weeks now, I think Ive read almost everything ever written about SMEMA protocol. The process seems so simple, it's killing m
1 |