Electronics Forum | Fri Apr 20 09:52:25 EDT 2018 | ushir
Hey everyone, Ive recently discovered a problem where components picked are moving on a nozzle during the vision scan. Pick and Place being used is an iPulse M7-3L. When the scan camera scans across the components, the components are shifting on the
Electronics Forum | Fri May 30 08:24:08 EDT 2008 | cyber_wolf
The nozzles get centered at zero degrees and 180 degrees. I believe the yellow asterisk is the measurement at zero degrees, when it rotates to 180 is when you will get a red X or a green O. (In other words the yellow asterisk is normal) I think you
Electronics Forum | Fri May 30 09:50:04 EDT 2008 | jdengler
Another sticky issue is that if you use after market nozzles especially mixed in with Fuji nozzles the Anti-Marking Illumination Disks can be different enough that the vision system will reject nozzles. Jerry
Electronics Forum | Fri May 30 09:53:19 EDT 2008 | cyber_wolf
"Another sticky issue is that if you use after market nozzles especially mixed in with Fuji nozzles the Anti-Marking Illumination Disks can be different enough that the vision system will reject nozzles. Jerry " Thats what I meant when I said they
Electronics Forum | Fri May 30 11:58:16 EDT 2008 | fredc
The right paper incorrectly applied can be a problem also. I have seen it on even new Fuji nozzles with the illumination disk bunched up on one side of the tube with a gap on the opposite side.
Electronics Forum | Fri May 30 10:18:34 EDT 2008 | jdengler
I've had some that under normal light they looked the same but when the UV light hit them they were very different.
Electronics Forum | Thu May 29 14:57:26 EDT 2008 | rodrigo
Hi all, Is it normal for some of the small nozzles to be rejected by the wide view camera? Every time I do a nozzle centering the narrow view camera shows green circles for nozzles 1,2,3,4. The larger ones (5 and 6) show the asterisk. The wide view c
Electronics Forum | Tue Mar 01 03:25:33 EST 2005 | bing
We are using a GDM with a linear piston pump fitted to dispence adhesive on 0603's. Use Universal part number 43273801 needle with a 42346504 piston. The single needle dimentions are 0.010 ID, 0.028 OD, 0.005 stand off
Electronics Forum | Fri May 17 08:43:46 EDT 2013 | fredcalkins
If you have Flexhead nozzles you need to be careful that whatever solvent you use does not attack the gasket adhesive. I might try a couple of drops of a spray like WD-40 or LPS. Let it soak for a few minutes and blow it out with compressed air. Repe
Electronics Forum | Thu Jan 03 10:32:38 EST 2013 | beej
I was wondering if any of you fine folks had a trick to changing out nozzles for a Pillerhouse Jade Handex. The tool they gave us when we purchased the machine is inadequate at best. I have tried heating the nozzle up, to no avail. Just wondering if
winsouce.jpg)