Electronics Forum | Tue Oct 09 14:25:33 EDT 2001 | cal
Most PIck and place manufacturers have off line feeder set up available. Dedicating common feeder types to one side and having the other side available for job specific is also an option. *****note dedicating feeders can effect your throughput num
Electronics Forum | Sat Oct 20 00:34:57 EDT 2001 | kenbliss
Hi mike The solution is simple but two fold, first your process needs to be changed a bit, you need additional feeders to pre-stage the new P/N run and prestage the extra feeders for reload as certain higher volume components exhaust. The idea is t
Electronics Forum | Sun Aug 22 17:12:55 EDT 2004 | Mark Hugill
Hi All I would like to know if there is software available to optimize placement files for Samsung machines. We are currently using the on-line software off-line but combine setups and just plain ordinary setups and optimization are painfully slow.
Electronics Forum | Fri Jun 12 15:06:45 EDT 1998 | Marcos Silva
| You can prepare your setup off line, using additional tables, and exchange very fast just sending the new program and checking using a barcode reader. Also you can edit a setup program with mixed feeders between PCB families. You can decrease your
Electronics Forum | Mon Oct 29 15:58:47 EST 2001 | davef
Kitting: Buy-in material in kit form that is complete and in the proper form. Line set-up: Layout all boards to be the same width. Printer set-up: Use a dispenser, instead of a printer. Dispenser set-up: Program & debug off-line. Placement machin
Electronics Forum | Fri Jun 11 11:42:14 EDT 2004 | Claude_Couture
hum, I see no problem for your people supporting any line that can run this speed. If your chip shooters are the dual feeder carriage kind, you must run them in replace mode, when one feeder runs out in one carriage, it parks it and continues running
Electronics Forum | Wed May 19 20:24:09 EDT 2021 | kumarb
Thank you Michal. Very much appreciated. We are thinking along the same lines. However, we are being very afraid to even cut the official wire ties that are securing the head 1 and head 2 wiring. We have a new VAC2 solenoid in transit that will arr
Electronics Forum | Fri Aug 20 05:50:40 EDT 2004 | finepitch
Yes, you need to use "dedicated feeders" and only make changes when you run out of a part. It may even be better if you could convince the stock room and keep stock for those parts right on your line. The environment has to be proper for that though,
Electronics Forum | Fri Jun 12 01:17:52 EDT 1998 | Erhard
Are you using extra feeder tables that you can setup off line and than just exchange for the ones you had in the machines for the previous batch? This way the Siplace should not be too bad. Otherwise for fast change and low volume you might look at m
Electronics Forum | Tue Apr 28 19:43:25 EDT 1998 | Michael Allen
I'd like to find a buyer for the following used equipment: Make: Universal Instruments Model: 4713D Adhesive Dispenser Options: Rotatable dual-dot head (0deg, 90deg) Price: Asking $4K (No reasonable offer refused) I should note that this d
