Electronics Forum | Fri Oct 03 04:24:54 EDT 2014 | dcarroway
Does any one have a wiring diagram for an electrovert Omni 10. We are having trouble finding why zone 7 runs over temperature.
Electronics Forum | Mon Oct 06 11:09:20 EDT 2014 | cyber_wolf
I dont have a schematic anymore but its most likely the SSR for that zone or the blower.
Electronics Forum | Wed Feb 02 20:06:29 EST 2022 | emeto
Any USB, CD or floppy disk inserted?
Electronics Forum | Thu Feb 03 13:06:27 EST 2022 | astarotf
None inserted. The hard drive is bad.
Electronics Forum | Tue Feb 01 15:17:10 EST 2022 | astarotf
Hi all If someone can help me get the software installers for the speedline omni 10E reflux oven, or any contact to help us with the reinstallation of the interface or software to operate said oven. Since the hard drive failed and all the files on
Electronics Forum | Mon Sep 08 18:14:00 EDT 2003 | Brian W.
I had an Omni10 that was set up for nitrogen, but also required a water chiller. Make sure your oven wasn't set up to be run with one. If, it was, I know a couple places that sell chillers which will meet the requirements. Brian W.
Electronics Forum | Wed Oct 08 11:18:41 EDT 2014 | wavemasterlarry
If its like my wave, the t-couple might not be mounted over a whole where the hot air blow out./ mounting it on the hot plate makes it over heat alot.
Electronics Forum | Thu Feb 17 00:13:58 EST 2022 | sarason
There are companys that recover discs like this by mounting that platters in a donor drive. The costs are usually very reasonable considering your downtime etc. sarason
Electronics Forum | Tue Mar 21 07:31:54 EST 2006 | cyber_wolf
We had the exact same problem on our OMNI 10. We found that two of the rails the pin chain rides in were warped. Somehow at one point our PC lost communication with the oven and the heaters went wide open for several minutes...this is what caused th
Electronics Forum | Tue Sep 11 08:36:53 EDT 2007 | cyber_wolf
We seem to have a lot of blowers going bad on our Omni 10 lately. We run PB free and/or elevated sn/pb profiles on a regular basis. I am starting to suspect that the elevated zone temps are causing the blowers to fail. Has anyone else had this prob
.gif)
