Electronics Forum | Mon Jan 15 18:15:15 EST 2007 | jaimebc
What test did you do to come to the conclusion that your conveyor is running 11 seconds slow?
Electronics Forum | Tue Jan 16 07:36:52 EST 2007 | leemeyer
Yes, these 2 pins are jumpered together. Thanks
Electronics Forum | Tue Jan 16 08:00:21 EST 2007 | leemeyer
Forget that idea. This is an informational screen and changes cannot be made.
Electronics Forum | Tue Jan 16 11:21:39 EST 2007 | leemeyer
I checked this and it seems to pertain to the rail conveyor only. We are using the belt conveyor. Thanks
Electronics Forum | Mon Jan 15 15:18:13 EST 2007 | jaimebc
We have an oMniflow 7 as well, and looking at the calibration procedure, it indicates that turning the pots ( total of 5 pots. 4 on the lower board and one on the upper board )fully counter-clockwise is the FIRST step of a series of tests. Then you w
Electronics Forum | Mon Jan 15 18:58:50 EST 2007 | leemeyer
Set the conveyor to run at 1 foot/minute and the conveyor moves 1 foot in 1:11. Set the conveyor to move 2 feet per minute and the conveyor moves 2 feet in 1:11. etc...
Electronics Forum | Mon Jan 15 19:21:08 EST 2007 | SWAG
Not sure if this has any bearing on the problem but did you check to see that T2 and T3 are jumped on the speed control board per the first note in the prodedure?
Electronics Forum | Tue Jan 16 07:44:48 EST 2007 | jdengler
This 11 seconds is constant? Seems like it's a clock issue. The machine thinks a minute is 71 seconds. Jerry
Electronics Forum | Wed Jan 17 21:19:08 EST 2007 | Jnet
I believe the drive of the conveyor whether rail or belt is the same so the sprocket choice in the software would effect belt or rail conveyor speed. I would make sure the number of teeth match the sprocket selection in the software.
Electronics Forum | Mon Jan 15 13:49:09 EST 2007 | leemeyer
Hello all, I am having some trouble with the conveyor speed on an Omniflow 7 reflow oven. Recent profiling showed that the conveyor was running to slow so I calibrated the speed using the instructions in the manual. After calibration there was no ch
