Electronics Forum | Thu Sep 28 16:25:20 EDT 2023 | SMTA-72837649
I've been looking for information on how, if at all, any of you treat water after a pcb batch wash. In particular, we have a Trident LD machine, using Zestron cleaning chemical. We have a carbon tank and two mixed bed media tanks as well as two 5 mic
Electronics Forum | Tue Aug 18 12:14:59 EDT 2009 | zanolli
We are looking for suppliers of liquid vapor degreaser batch equipment for flux residue cleaning of PCB’s. Any recommendations? Thanks
Electronics Forum | Tue Jan 11 10:02:43 EST 2005 | jdumont
Good day all, we have an evaporator for our PCB washer that has been fine up until recently. Everytime we run it, it boils over and makes a HUGE mess of everything. Any suggestions as to why this could be happening? Is it possible the temp controller
Electronics Forum | Wed Dec 02 05:09:18 EST 1998 | Jacqueline Coia
Hi, I'm looking for a small batch convection oven that will replace the dryer section of a batch ultrasonic cleaning machine to dry off excessive water from washed PCB's, any suggestions for particular suppliers, will be appreciated. Jack
Electronics Forum | Fri Dec 04 17:17:18 EST 1998 | EFData
We have a Heller 942 that is completely operational but not being used; we would be happy to entertain any offers if this did, in fact, meet your requirements. | Hi, | I'm looking for a small batch convection oven that will replace the dryer section
Electronics Forum | Wed Dec 02 09:28:24 EST 1998 | Dave F
| Hi, | I'm looking for a small batch convection oven that will replace the dryer section of a batch ultrasonic cleaning machine to dry off excessive water from washed PCB's, | any suggestions for particular suppliers, will be appreciated. | Jack |
Electronics Forum | Sat Jun 12 17:01:44 EDT 1999 | Murray Pulman
We are using so called no-clean fluxws for our small batch production, however the results are not always very visualy pleasing with white powdery deposits being the norm. I would like advise on the best avenue to explore for a small batch cleaning s
Electronics Forum | Fri Jan 29 21:31:46 EST 2010 | aqueous
I would recommend the following paper entitled "Cleaning for Reliability Post QFN Rework" by Mike Bixenman (Kyzen) and myself (Aqueous Technologies). While it discussed cleaning under QFN's in a batch environment, it is also applicable to cleaning u
Electronics Forum | Sun Jun 13 05:46:21 EDT 1999 | Brian Ellis
Murray "No-clean" fluxes/pastes should not normally give "white residues". Before exploring cleaning, which is costly for small production levels, I suggest you may care to find out why you have these residues. To help you, can you please answer th
Electronics Forum | Wed Jul 21 17:49:52 EDT 2004 | jsk
problem: Too many solvents and boards are not clean Flux remains on the board after vapor degreaser and "Powdery" white residue after vapor degreasing Flux type is kester 186 Process: hand solder High Temp alloy, spot clean after hand solder e
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
