Electronics Forum | Tue Dec 19 08:14:47 EST 2006 | davef
We agree with Chunks. You need to fix your machine. Tell us about: * Temperature inside machine when glue pipes well and went glue pipes poorly * Pressure on cylinder when glue pipes well and went glue pipes poorly
Electronics Forum | Sat Nov 03 10:57:27 EDT 2012 | davef
EricR: Regarding "*** By the way, since we have used the Tin-Silver-Copper lead free solder there has been a strange liquid type chemical leek from the oven exhausted pipes." ... I don't know anything about your process, but the first thing I'd inve
Electronics Forum | Thu Dec 26 17:01:59 EST 2002 | alandra516
Store the flux stone in PVC pipe (capped at the end) and fill the pipe with Isopropyl Alcohol.
Electronics Forum | Wed Mar 20 14:54:15 EDT 2024 | linux
Vacuum Low, Shows up on changeover when the head picks a different size nozzle, remove mesh filter, unplug the clear pipe from the top of the head, put a small amount of alcohol down the pipe and blow it out with the air gun, You should check for a h
Electronics Forum | Sun Jun 24 16:06:49 EDT 2007 | hussman
Check your local building code first. A lot of people 'say' they use various types of pipes. If you're looking for a complete system, try Patton Sonic. They're piping section is at; http://pattonsinc.com/piping.htm
Electronics Forum | Tue Mar 31 19:50:22 EDT 2009 | davef
8 bar is over 100 psi. What are you using that much pressure? So, your piping is made of what material? * Black iron * Copper Can you run soft pressure piping to by-pass the section that requires sealing?
Electronics Forum | Fri Jan 19 05:46:59 EST 2018 | ivammendes
MYDATA MY9E: Hydra's pipe can't stop the vacuum during assembly. The problem ocurre just in only one pipe, the number 5. The tool picks components but doesn't drop it. Can the problem be in the unit vacuum?
Electronics Forum | Wed Aug 14 10:11:01 EDT 2002 | davef
For relow ovens the general approaches are: * Clean the vent pipe. * Replace [a section of ] the vent pipe. * Clean the flux trap on newer ovens. * Do nothing and wonder where that brown slime that is dripping on the boards is coming from. For wave
Electronics Forum | Wed May 20 16:07:22 EDT 2020 | stephendo
You want a big enough storage tank to smooth pressure. Figure out what size pipes you need and go a size bigger. Make a loop of the pipes with shut offs. That way you can shut down any section and still have air to the rest of the air line. Run the p
Electronics Forum | Wed Jan 20 14:28:50 EST 1999 | Dave F
| I have a severe problem with flux residue being drawn up the vent ducts of my reflow oven. This residue reaches a critical mass then begins to flow down the ducts and becomes very messy. I run a no-clean process and use IR oven. Has anyone else o
