Electronics Forum | Fri Apr 08 21:39:17 EDT 2011 | jimlas53
Hi, We have a Quad IVc set up with all picks, placements, and sequence working. I have managed to get through several passes with some pain, mainly from SOT-23 parts, but it is getting better. On occasion, when picking from one of three feeders loc
Electronics Forum | Mon Apr 11 08:27:10 EDT 2011 | leemeyer
I have had similar problems before where the machine will intermittently stop with a limit error. Reset the machine and away it goes. Replacing the ribbon cable that runs from the head (37 pin D-sub)has solved this problem. This cable gets flexed a l
Electronics Forum | Sun Feb 03 07:36:17 EST 2019 | dfl
Hey Steve, I wrote to Bob, but he doesn't reply yet. Digging around, I found these: HANDLING COMPONENT VARIETY The adjustable Pocket Index function enables handling a variety of component tape reels or special component packaging. The following ins
Electronics Forum | Thu Dec 29 04:19:52 EST 2005 | lvqp72
We've run into a persistent QA error 99 on one of our Quad IVC's. Have checked upon all the obvious and found no bad components. Do appreciate any advice on this problem. Thanks.
Electronics Forum | Wed Apr 10 15:05:23 EDT 2013 | microaide
I followed your instructions and did NOT select the option to break up the program for separate central controllers. I now have a program I can copy to central controller #1, and I can delete the head 2 data from the program. Now when I select RUN TH
Electronics Forum | Sun Jun 07 11:47:10 EDT 2020 | saduquette
Hi, I went to run my IVC yesterday and it got a Motor Error on first pickup. Pressing Enter showed Z:-27:0 So according to the manual that means the Zaxis was commanded to go to -27, but the limit is '0'. I tried a Function 3 on that pickup and
Electronics Forum | Wed Feb 11 14:17:08 EST 2015 | bobpan
Glad I can help....if you run into anything else....you can find my e-mail @ www.precision-repairs.com Thanks, Bob
Electronics Forum | Sun Jan 27 17:59:25 EST 2019 | bobpan
The y-axis on that machine is left to right. If this is the axis you are having a problem with....check the motor. I have had to tighten the tension on it before. If you notice you lose steps after running for a while then this is going to be the iss
Electronics Forum | Thu Apr 11 07:45:44 EDT 2013 | leemeyer
I have never run across that error message before. Does the machine have Upward vision? Does this message only occur when trying to run programs that were generated by Autoprogram ? I think that I would create a new program with only 1 component, a r
Electronics Forum | Sun Jan 20 17:55:49 EST 2013 | ngineer
Mikej, I'm only running a single image, just want to correct for the slight variations in how the board seats in the transport. It's not more than a few mils off, but enough to cause an issue on fine pitch parts. I don't have any image fiducial
winsouce.jpg)
.gif)
