Electronics Forum | Wed Oct 23 12:06:09 EDT 2002 | russ
It sounds like you already know the answer! How much does it cost you to solder P.T.H. by hand (number of pins/per hour, / cost of assembler) vs. wave preparation and time of loading/masking etc... Cost of rework from each process? Only you can mak
Electronics Forum | Fri Oct 26 06:25:56 EDT 2001 | John
Undertaking tricky rework project to remove two BGA's in close proximity to two press fit dip sockets any guideline sone should use??? proceddure ,process control etc
Electronics Forum | Tue Apr 23 14:30:35 EDT 2019 | scotceltic
I would like to setup a guideline for BGA to components around it minimum distance. To allow for rework possibilities of the BGA. What are people using as a minimum clearance out there ?
Electronics Forum | Fri May 30 04:20:59 EDT 2003 | Ben
Hi all I am facing the problem with reoworking CSP component for high frequency application boards. Our customer do not allow us to use tacky fluxes due to high frequency application and component has low standoff ,and the ball pad and ball size is
Electronics Forum | Tue Oct 15 15:00:33 EDT 2002 | Steve Walters
Is there any info, guidelines or spec's on how many time you can rework a bga location?
Electronics Forum | Tue Oct 15 20:33:43 EDT 2002 | davef
First, this is a very interesting question. Second, there is no specification. Third, companies develop guidelines for rework based on their expectations for their product reliability. Things to consider are: * Motorola allows no product shipments
Electronics Forum | Tue May 27 10:06:13 EDT 2003 | John S
Can anyone provide information on acceptable temperature control for SMT and Through hole rework? I've found IPC's guidelines, but I didn't see any specific temp guidelines. Our component vendors are being silent as usual. Thanks in advance, John
Electronics Forum | Fri Jun 12 13:47:20 EDT 1998 | Enza Hill
The SMTA Great Lakes Chapter (Chicago area) is holding a Rework Symposium on June 30th. (I know REWORK is a dirty job, but some of us have to do it!) We will have several speakers in the morning on the following topics: - Rework Management & Optimi
Electronics Forum | Fri Oct 20 11:23:33 EDT 2006 | mmjm_1099
Good morning/afternoon/evening everyone! I am seeking the assistance/guidance of anyone who has had practical experience with placing, soldering, and rework of this particular component. One of our customers is looking to use this component on quit
Electronics Forum | Thu Dec 28 20:56:08 EST 2000 | Dave F
This is not a real demanding job. We've talked about materials sources before, check the fine SMTnet Archives. Responding to your question, try: Circuit Repair Rowley,MA 508-948-7973 [Jeff Ferry is a contributor to SMTnet, so ya gotta go there fir
