Electronics Forum | Tue Sep 18 20:50:35 EDT 2012 | vergara1
ATTENTION*****Sorry I missed informed you on the second tip; tip should be set at 399C/750F.******** Melissa
Electronics Forum | Tue Aug 23 12:13:02 EDT 2011 | richieoreilly
Hi, We are currently having issues with hand soldering High melting point solder wire. Can anyone give a few tips. We are Preheating boards to 120 deg C and using soldering irons @ 410 deg C. The quality is ok but the ts taking 20-30 seconds to c
Electronics Forum | Tue Sep 18 20:01:46 EDT 2012 | vergara1
Thanks for the advice. We have only done one PCB > with HMP solder and did not use preheating, but > I've been wondering if it would have been helpful > since we had some trouble getting the solder to > flow. If you have any more specific advice
Electronics Forum | Sun Aug 07 13:12:45 EDT 2005 | Patty Chonis
Hello We sell soldering stations that can heat up to 200 celcius in less then 20 seconds. The temperature settings are variable and can be pre-programmed. The stations are very competitively priced and can handle home soldering applications. Please
Electronics Forum | Thu Feb 27 16:23:37 EST 2020 | dwl
http://www.circuitnet.com/news/uploads/3/Comparing-Soldering-Results-of-ENIG-and-EPIG-Post-Steam-Exposure.pdf Years ago, I battled this problem. ENIG PCBs reflowed with active WS flux. We built one side, and then washed them because they were going
Electronics Forum | Thu Jul 17 08:45:22 EDT 2008 | edmaya33
MPM momentum will be fine. most second hand machine are headache. Can be acquire in low price but paying more on maintenance.
Electronics Forum | Sat Aug 03 05:05:08 EDT 2024 | ttheis
We have also had pretty good luck with DEK second hand.
Electronics Forum | Wed Oct 06 20:02:10 EDT 1999 | KEVIN SIMPSON
| | I am loking for second hand panasonic feeders MVII and MPA. | | Please tell me characteristics, price and waranties. | | | | What are you looking for ? What sizes etc? With the MVII you are capable of using a dual reel feeder.If you run these
Electronics Forum | Tue Jul 14 07:58:33 EDT 1998 | Bill Woehr
| I am eager to hear from anyone who has experience with X-RAY inspection equipment (specifically for BGA devices) or can make any recommendations. Any knowledge of second hand equipment for sale would also be valuable. | Regards | Rob Hello Rob I am
Electronics Forum | Wed Jun 01 03:06:56 EDT 2005 | Base
Reading all of the above, the differentiators seem to be very hard to spot by looking only at the quality of the iron and how it is bolted together. Perhaps you should broaden the equation and look at the quality of service that comes with the (secon
