Electronics Forum | Fri Apr 29 23:52:03 EDT 2022 | Stevekilic
Hello, I have a problem with Dek horizon 03ix machine software hangs on the start screen. What could be the matter.
Electronics Forum | Wed May 25 12:09:52 EDT 2022 | stevemiles
Hi, I've had this problem with two DEK Horizon 03i printers. The first time it was the camera (firewire) causing the PC to freeze. The second time it was the firewire card in the PC that was the problem. Try moving the camera firewire cable to a d
Electronics Forum | Thu Dec 11 08:20:05 EST 2003 | liang
we ofen have the problem of the part missing.when problem take place .we found the segment sleeve is anomaly.we change the sleeve is ok!but we don't know what is wrong with the sleeve.who can help us ,thks!
Electronics Forum | Mon Dec 15 22:05:02 EST 2003 | Sam
hi Liang, We had the same problem like you before, it happened during starts up the machine (S13) and run the production for the first or second board. We also replaced the 2/2-way microvalve of placement circuit. The problem had solved at the begini
Electronics Forum | Sat Dec 13 08:03:46 EST 2003 | Stefan Witte
The only part, which could cause component misplacement on the rotary heads of the Siplace machine is the vacuum valve. I don�t know the official name in the part catalog, but I use to name it plunger. The plunger is moved in and out by a miniature s
Electronics Forum | Sat Oct 03 15:51:06 EDT 2015 | amrsalama
I have the same problem and while using logicomm it gives an error message (FC107F24) !!! how can I read this error to address the problem ???
Electronics Forum | Wed Aug 12 17:41:15 EDT 2015 | edwaterfall01
Sorry for all the typos in the last message. As the machine was powered OFF for two weeks I would have expected a battery problem. Can you capture a Logicimm file and see what the file says before the heart beat messages?
Electronics Forum | Sun Oct 11 10:00:11 EDT 2015 | brockparry
if you are facing a problem to send the data to your machine then you must check the driver part of your machine if you are sending it through any software. Also check the power status of the machine. You can also go for one simple method by doing Re
Electronics Forum | Thu Oct 12 12:51:39 EDT 2006 | john_smith
Hey Brian how are you doing? We also have one of these feeders and it works great! The best feature is the being able to reverse the feed wheel to backfeed parts. Just talked to the guys at Hover-Davis yesterday and they have had feeders in service
Electronics Forum | Tue May 07 13:49:05 EDT 2019 | tey422
Like I stated before, I am not familiar with the machine. I can only make suggestions. If you found solder paste on the nozzle, clean it off to prevent part stuck to the nozzle tip. I would also check if the nozzle tips are being worn off; uneven we
winsouce.jpg)
