Electronics Forum | Wed Nov 05 19:40:25 EST 2003 | Mike Konrad
Here's the official press release... New York, NY (November 5, 2003) -- KPS Special Situations Fund II announced today that it has acquired the stock and related assets of Speedline Technologies, Inc. from Cookson Group, plc for a total consideratio
Electronics Forum | Wed Apr 26 18:35:07 EDT 2023 | poly
I'm looking to make a board support table fixture that is connected to the printer and uses the vacuum manifold of the printer. Printer is an mpm Accela
Electronics Forum | Wed Apr 26 19:10:43 EDT 2023 | cyber_wolf
This machines support table looks similar to AP and UP machines. I believe MPM published the dimensions of the "H" tower that the dedicated plates bolts to. As far as the plate, they are typically (2) pieces with the inside hollowed out to allow for
Electronics Forum | Thu Nov 08 07:45:03 EST 2007 | hussman
We use the Gel Flex from MPM. Made a different base for each machine. Works well for most boards, but you may need additional pin support for larger boards. No tools, no vaccum hoses, no missprints (which Grid Lock is famous for), and best of all
Electronics Forum | Mon Nov 12 08:04:15 EST 2007 | samir
In my past life, I used a tooling plate by JNJ that is specifically made for MPM's. The theory is - it's an alphanumeric grid, like Battleship, where you figure out your setup once, and then document it. It worked with and fit nicely with the MPM H
Electronics Forum | Mon Aug 27 15:50:05 EDT 2001 | seand
Hello Everyone, The MPM UP 3000 may be a good bet for your Screenprinting application and I am aware that there are a few in inventory at Speedline Technologies (MPM) that you should be able to get with a warranty for a good price. I know wide vers
Electronics Forum | Fri Apr 21 00:56:44 EDT 2006 | pavel_murtishev
Good morning, MPM AP25 we have is equipped with dedicated vacuum support only, no side snuggers. Also we had a lot of issues with fine pitch paste deposition due to this poor support. Vacuum support can�t fix wrapped boards properly causing a lot of
Electronics Forum | Tue Jan 13 19:16:03 EST 2004 | pjc
Dedicated tooling uses what MPM calls an "H" tower. You mount the board support plate (dedicated tooling) on top of the H tower. If boards are only single-sided SMT, meaning only components on one side, the board support plate is flat with vacuum hol
Electronics Forum | Fri Apr 30 15:11:53 EDT 2004 | pjc
MPM has a new board support system called GelFlex. It can be used on UltraPrint 2000 machines as well as AP series, UP1500 and AccuFlex models. For more info, go to http://www.speedlinetech.com/mpm/gel-flex.aspx also, contact Chris Wild at Speedline
Electronics Forum | Wed Nov 20 16:27:15 EST 2002 | pjc
FYI: MPM does in fact offer alternate board support tooling than the vacuum box system. They have the X and Y snugger tooling, which clamps the board and uses magnetic support pins. If you are looking at a used UP2000, check to see what tooling it ha
winsouce.jpg)
.gif)
