Electronics Forum | Fri May 27 13:20:06 EDT 2016 | elton111
how are you. I have a problem with a table that the issue errori topaz. The issue is the message "Bring back component." a problem with the pick up parts vacum setting level is 100 and the current 111 with vacum head is 6. Can u tell me how to Calibr
Electronics Forum | Tue Mar 27 02:37:35 EDT 2018 | rob
Hi Thomas, Yes, we are pretty good at feeder maintenance, we gang pick on our Yamaha/Assembleon kit with no issues. On one of our older machines (YV112-3/Sapphire) we pick 12 LEDs at once per side of the machine. On a couple of jobs we exceed the ma
Electronics Forum | Mon Nov 12 08:56:32 EST 2007 | chrisruizuci
im looking to buy a pick and place machine and right now the two that have caught my eye are the Philips Topaz and the Mydata TP9. just tring to figure out which is better?
Electronics Forum | Mon Nov 12 12:00:59 EST 2007 | wayne123
A philips Topaz is a good machine, I have accurately placed 0402's without a problem, Fine pitch QFP no problem, BGA's not a problem, I am not familiar with the TP9 so hopefully the other guy can answere questions on that, The Topaz is rated at about
Electronics Forum | Mon Nov 12 13:35:34 EST 2007 | dyoungquist
MyData TP9s Work well in high mix applications because change over time from 1 job to the next can be done in as little as 15 minutes if you have the right mix of magazines/feeders. Component placement rates vary depending on which component you ar
Electronics Forum | Wed Jul 29 08:38:26 EDT 2009 | duchoang
I am not sure about Topaz, but with Topaz XII, that problem could be the filter clogged, too dirty or installed improperly.
Electronics Forum | Fri Jul 24 07:56:40 EDT 2009 | thanhnguyen
hello all I have a Assembleon Topaz. at head # 2 everytime it going down to pick up the part, it just blowing the part off from feeder, i did replace vacuum vale but still doing the same. any input is helpful. thanks
Electronics Forum | Fri Jul 31 17:09:55 EDT 2009 | isd_jwendell
Don't know about Topaz, but on Essemtec machine using SMC ejector, there are separate solenoid valves for vacuum and release. The connectors are identical and side by side. If these connectors were swapped then I would have the symptoms you describe.
Electronics Forum | Wed Jun 10 01:33:20 EDT 2015 | leeg
Are the leaf springs in good order and set right? If they are then it could be calibration related.
Electronics Forum | Wed Jun 10 01:35:07 EDT 2015 | leeg
Does head 7 calibrate ok? Is it a bent shaft?
winsouce.jpg)