Electronics Forum | Mon Jul 13 13:48:37 EDT 2009 | christian01976
Hello! You can check your vacuum in MANUAL and then VACUUM IN MONITOR. You can switch the vacuum on or off for each head. With a TYPE 72 nozzle and no component the vacuum should be around 80 or 90 and with a component at the nozzle it should be ove
Electronics Forum | Tue Jul 14 13:45:04 EDT 2009 | christian01976
Hello! You could check your pick an mount vacuum, too. You can do it in COMPONENT INFO with the ADJUST ASSISTANT (F6). Then PICK UP COMPONENT. If you don´t know how to read the grafic that is shown then just push F1 for HELP. What size do the TANT h
Electronics Forum | Wed Jul 15 20:04:13 EDT 2009 | tonybb
We just bought an used Omron AOI machine and have no prior experience with it. We powered it up and found out that the machine failed to boot-up because there was no internal hard drive (C: drive). Apparently, it has two external hard drives connect
Electronics Forum | Thu Jul 16 08:06:07 EDT 2009 | esolano
Tekmart is seeking a FUJI service technician/engineer for service support work in Arizona area. The exact location of our warehouse is Nogales Arizona. Please contact us at salestor@tekmart.com so that we can discuss further. We look forward to worki
Electronics Forum | Thu Jul 16 22:02:01 EDT 2009 | tpappano
The manual says (paraphrasing) "If the ball screw needs lubrication, lubricate the ball screw". Not very helpful 8-) The various linear guides all have grease fittings, but I can not find any for the ball screws. Any advice from CSM84 users woul
Electronics Forum | Fri Jul 24 11:56:24 EDT 2009 | stepheniii
I've had the relay that controls closing the lid go bad It's a solid state relay if I remember correctly. Are you talking about a motor driven lid? edit now I"m trying to remember if that place had conceptronic ovens and that's what I"m thinking of
Electronics Forum | Mon Jul 20 06:46:50 EDT 2009 | brucow
Hi All, If anyone knows the default password to enter the BIOS on the Philips Comet 1 machines it would be much appreciated if you could post it here. I am trying to replace the hard drive in our machine with a standard 4GB unit formatted to 40Mb bu
Electronics Forum | Mon Jul 20 11:46:18 EDT 2009 | msherwood
I’m having trouble with the transfer of one board from the UIC conveyor to a DEk screen printer. They are set up for SMEMA to SMEMA but the DEK keeps asking for a aboard when it already has one. Then it will ask for one every 5-8 seconds. DO I have a
Electronics Forum | Thu Jul 23 09:30:22 EDT 2009 | dekhead
It isn't clear if it was working and stopped, or if this is the first time you've tried to make it work. If this is first try, need to confirm cards and cables on DEK, and what interface is configured on UIC. I have SMEMA cards in stock if needed. P
Electronics Forum | Thu Jul 23 13:09:04 EDT 2009 | dekhead
We're most likely looking at X9 Personality card... You can swap X8 and X9. Can't recall seeing a failure in SCB40 in the 15 yrs I've been doing this. If not the personality then the PCIB (#5) in the PC. Feel free to contact directly (dh1@dekhead.c
winsouce.jpg)