| https://www.eptac.com/soldertip/soldertips-dealing-with-the-problems-of-soldering-iron-tips-breaking-down/
. We are soldering lead free materials between 600 and 700 degrees F and increasing the contact dwell time by about 1 to 1.5 seconds. The new lead free alloys are high in tin content and the tin will dissolve the plating on the solder iron tip and eventually eat through the tip
| https://www.eptac.com/faqs/soldertips/soldertip/soldertips-dealing-with-the-problems-of-soldering-iron-tips-breaking-down
. We are soldering lead free materials between 600 and 700 degrees F and increasing the contact dwell time by about 1 to 1.5 seconds. The new lead free alloys are high in tin content and the tin will dissolve the plating on the solder iron tip and eventually eat through the tip
Heller Industries Inc. | https://hellerindustries.com/low-void-curing/
. Issues Caused by Voids Reduced adhesion of device to substrate Reduced thermal performance Electrical failures from “solder creep” Lower reliability & shorter lifetime Pressure Curing Removes Voids As pressure is increased, more gas molecules are able to dissolve
| https://www.eptac.com/soldertips/soldertips-gold-removal-and-wave-soldering-vs-hand-soldering/
. If the components are going to be wave soldered then just install them into the board and use the solder from the wave to dissolve the gold
Blackfox Training Institute, LLC | https://www.blackfox.com/blackfox-how-to-make-a-printed-circuit-board-at-home/
. Place the printed plate in warm water for about 10 minutes. The paper will dissolve. Remove the paper gently. If the tracks get fainted, use the black marker to darken. 5. Etch the Plate
Imagineering, Inc. | https://www.pcbnet.com/blog/dissolving-barriers-how-water-soluble-printed-circuit-boards-could-solve-e-waste/
that dissolve in water. Promising solutions such as Soluboard, a flax-fiber-based composite material developed by Jiva Materials now exist
Blackfox Training Institute, LLC | https://www.blackfox.com/news-events/blackfox-how-to-make-a-printed-circuit-board-at-home/
. Place the printed plate in warm water for about 10 minutes. The paper will dissolve. Remove the paper gently. If the tracks get fainted, use the black marker to darken. 5. Etch the Plate
| https://www.eptac.com/soldertip/soldertips-gold-removal-and-wave-soldering-vs-hand-soldering/
. If the components are going to be wave soldered then just install them into the board and use the solder from the wave to dissolve the gold
| https://www.eptac.com/faqs/soldertips/soldertip/soldertips-gold-removal-and-wave-soldering-vs-hand-soldering
. If the components are going to be wave soldered then just install them into the board and use the solder from the wave to dissolve the gold
winsouce.jpg)
