Electronics Forum: (4) (Page 326 of 630)

Pick & place

Electronics Forum | Sat Mar 24 17:55:25 EDT 2007 | colormaker

Dear forum We are in the market for a new /used machine pick place machine with 15 mil accuracy. We have been using a quad 4C for 7 years and it seems like each week we put more money into repairs. I have looking into several machines but it seem l

Pick & place

Electronics Forum | Mon Mar 26 17:20:46 EDT 2007 | coop

I use a Philips topaz, Have been running them for 6 1/2 years and have had great luck with them and assembleon is about as good as it gets when it comes to tech support. I am not a vendor just a machine operator. I am familiar with the quad 4c and th

Pick & place

Electronics Forum | Wed Mar 28 20:35:52 EDT 2007 | darby

Quadalign is very similar to the Samsung. I would think that 4% dump on 1206 or even IC is way over the top. If you are certain that your component data is correct; I suspect that your z-axis centring height may be out of whack and that you are eith

Rigid Flex Wave Soldering

Electronics Forum | Wed Apr 04 19:31:57 EDT 2007 | rgduval

Dave, We're reworking with flux and solder. We're observing "exploding" joints, as well...as though something is trapped in the joints (either excess flux not burning off during solder, or residual moisture). As mentioned above, I spoke with the f

GSM Machines

Electronics Forum | Tue May 01 16:36:12 EDT 2007 | ratsalad

I have been working with GSMs since 1999. Mostly, I've been programming them but for the past 2 1/2 years or so I've also gotten to know them mechanically. I think they are great machines. If you are looking at Flex head GSMs (4-spindle) they won'

GSM Machines

Electronics Forum | Wed May 02 12:22:30 EDT 2007 | SWAG

Make sure you get a good upward looking camera combo. 4.0 on rear and 2.6 for PTF (platform tray feeder) parts is my favorite. Easy to wrench on, calibrate (if you have a cal. kit), and easy to program. Single beam will run at 2000+ cph and dual b

SMT FEEDER SETUP

Electronics Forum | Wed May 09 12:14:08 EDT 2007 | mmjm_1099

I am wondering if anyone has tried to run a crystal report out of Fuji Flexa? What I would like to do is run the report that make a default feeder list for that certian day to minimize feeder setup times. So please leave me some feedback if you have

Mass Lead Trimming of Clinched Leads

Electronics Forum | Fri May 11 07:38:14 EDT 2007 | tombr

It is possible to vary the length of lead during auto insert. However, it requires software and mechanical adjustments. Universal equipment allows small changes via software program for lead length. To change angle of clinch involves a mechanical a

Solder wave shutdown

Electronics Forum | Tue Jun 05 10:01:47 EDT 2007 | bartlozie

the temperature difference between solder and room temperature, So if you let the solder cool down, you need less energy then holding it on temperature + heating a bit up. 2. If you let the solder get to solid, you don't have oxidation. 3. If you l

Prototype SMT assembly machine

Electronics Forum | Sat May 19 02:42:03 EDT 2007 | vinitverma

Hi Bart, I suggest you have a look at Assembleon's OPAL XII. They have a special offer at this moment. You can select the machine with 4 heads (standard) and later if higher speed is needed, you can upgrade it to 8 heads. the machine is capable of h


(4) searches for Companies, Equipment, Machines, Suppliers & Information