Electronics Forum | Thu Jul 23 13:09:04 EDT 2009 | dekhead
We're most likely looking at X9 Personality card... You can swap X8 and X9. Can't recall seeing a failure in SCB40 in the 15 yrs I've been doing this. If not the personality then the PCIB (#5) in the PC. Feel free to contact directly (dh1@dekhead.c
Electronics Forum | Fri Dec 18 05:09:03 EST 2009 | andythornton
Hello SMT people. New member - first post.... "Have you considered a refurbished SMTech Benchmark printer from SigmaPrint?" I tried that. The reply I received stated that they hadn't had any for years (despite showing them as available on the site
Electronics Forum | Fri Feb 19 09:34:27 EST 2010 | baildl632
Thanks for the support. Maybe you can help me with another problem. I get a pate dispensor error command time out, which clears itself, then a screen actuator error command time out that doesn't clear during initialisation. Machine won't do anything
Electronics Forum | Thu Apr 01 18:13:19 EDT 2010 | dman97
Since my last post, I have successfully calibrated my printer. Now I have noticed that after a print, the machine decides to check for fiducials again. A post print fiducial check. Do you know how to disable this? It is slowing down my process co
Electronics Forum | Mon May 03 08:09:04 EDT 2010 | Jeff
Power up your machine and look at the vision card. If it has a red light then there is a problem with it. 20k is way to much to spend to fix this. I've sent out two cards for repairs in the past and got them fixed for $2200 each. If you want more inf
Electronics Forum | Sat Jun 05 09:24:40 EDT 2010 | dekhead
As stated, that error relates to rail lifted sensord (L & R)... Machine is perceiving that something is causing rails to lift at inappropriate time. You can monitor sensor status in Rising Table diagnostic to see that they are toggling appropriately.
Electronics Forum | Mon Sep 20 13:43:40 EDT 2010 | dman97
Hi, Yes I dont have any estops engaged. Like I said, I can press the system switch and I can hear the locks engage, but it will not give me an option to lower the hood. I have tried turning the maintenance key, but nothing shows up on the monitor.
Electronics Forum | Mon Sep 20 14:23:50 EDT 2010 | dekhead
No, there is not a way to initialise into the diagnostics menu with the head raised / covers open. Literally lowering the head manually (prop head, disconnect actuator, etc) is naturally possible, but not receommended... and based upon your symptom
Electronics Forum | Fri Apr 08 15:27:05 EDT 2011 | stimpk
A couple more things to look at. ( DEK) Check you wiper blades. This is the rubber blade that holds the paper in contact with your stencil. When these wear down it will not clean properly. Also make sure when you run this product that you verify that
Electronics Forum | Tue Aug 02 17:55:33 EDT 2011 | dekhead
A couple of points; DEK abandoned Phlegmington, NJ back in '09, and is now USHQ in Rolling Meadows, IL Tel: +1 847 368 1155. A newcomer to the states you might want to look at as well is: Speedprint Speedprint Technology, Americas’ 5804 Breckenrid