Electronics Forum | Mon Jan 18 20:38:02 EST 1999 | Dave F
| I am looking for a "general guideline" for assembly processing these types of assemblies. Do any exist? | John, try the following link to get started:
Electronics Forum | Fri Jan 08 02:27:00 EST 1999 | Kwang-Seong Choi
HI! I am a package engineer in Korea. I have some reasons to desolder excessive solder at the lead of TSOP and TSOJ after removing them from the board. The way with solder wick is too time-consuming and depends on the operator. Does anyone know the
Electronics Forum | Thu Dec 24 02:21:15 EST 1998 | Chris Grendler
Any one know a good stencil vendor who can produce stencils below .002" foil with appetures at .004" on .008" pitch? AMTX use to be my vendor but they are closed down. Thanks, Chris Grendler
Electronics Forum | Thu Dec 03 02:42:11 EST 1998 | Michael Fogel
Does any body knows of a used Universal Wire Wrap machine in a good operational condition? Please contact with me or with Roni Haviv (972-7-998-6673) Thanks.
Electronics Forum | Wed Dec 02 05:09:18 EST 1998 | Jacqueline Coia
Hi, I'm looking for a small batch convection oven that will replace the dryer section of a batch ultrasonic cleaning machine to dry off excessive water from washed PCB's, any suggestions for particular suppliers, will be appreciated. Jack
Electronics Forum | Wed Dec 02 08:36:17 EST 1998 | Wayne Bracy
| Our CP feeder take up reels often break,The glue in tabs | are a pain and replacement is expensive.Any solution? | You might want to call Hover-Davis (716)352-9590 for information on their replacement parts and new feeders. Wayne
Electronics Forum | Wed Nov 25 20:02:38 EST 1998 | john jong
I like to know under what conditions the reflow profile of a solder paste is taken? Bare board, board with the solder paste, or board with high melt solder paste?
Electronics Forum | Thu Nov 12 08:52:02 EST 1998 | Wayne Bracy
| First, appologies to y'll for creating an opening for bs@ss to post the usual thinly cloked commercial message. | | Second, how do you test, measure, determine if your stencil is clean? | | Thanks | | Dave F Here I go stepping into it! check
Electronics Forum | Mon Nov 02 20:26:18 EST 1998 | bernie
What programming software is available for the Philips FCM? I currently use the Philips PPS software, but the user interface is less than desirable. Surely there is something better.
Electronics Forum | Mon Nov 02 10:49:42 EST 1998 | Larry Johnson
Not sure if you are intrested in refurbished thru-hole equipment, can save big money going that route. Contact Mike Wales with Lakota International. Their website is www.lakota.com. I am sure he can help you out. Be sure to use my name. Thanks L