Electronics Forum | Fri May 28 13:03:14 EDT 2021 | cbart
I'm honestly not sure IPC addresses this? the one thing i would ask myself if it were my issue: is the effected area in the critical contact area of the finger/contact? in other words if its low on the finger where the bevel was applied i bet its not
Electronics Forum | Mon May 03 15:16:01 EDT 2021 | capse
Thin FR4 can be routed with a CO2 laser with high quality results, the edge is precise and free of slag. The process is extremely low stress. If the edges are straight you can consider sawing. 0.4mm (0.016") FR4 can be laser routed and sawn at spee
Electronics Forum | Wed Jun 02 20:15:03 EDT 2021 | jamesatqkits
Hello wonderful people. Does anyone know if I can get away with a 1mm fiducial on a Samsung CP45, I know the manual states the beam is .6mm and Fid's should be 2mm. Anyone have experience with this? Thanks, James in Canada have a great day everyone.
Electronics Forum | Mon Aug 16 03:23:29 EDT 2021 | korrapat905
Hi Kristof_K Thanks for advice, I try but still same. Afer checked, it's look the supply voltage not send out from panel to supply sensor and inverter. Now I rty to find new panel from 2nd hand. Thank you
Electronics Forum | Thu Aug 12 20:41:01 EDT 2021 | globalpowerproducts
Any idea how to get the machine to see this part and place it square??? I am really struggling. I have tried it as a BGA but it never works The part is on page 43-44 https://connectivity-staging.s3.us-east-2.amazonaws.com/2019-03/CS-DS-BL654%20v1
Electronics Forum | Fri Sep 03 07:33:46 EDT 2021 | sophyluo1985
Sorry, sir, I don't want to disturb you, or have other thoughts. I know you will not trust Chinese people now, but we want you to know that not all Chinese suppliers are like this. You can try to contact GOLDLAND, there will be no loss for you, maybe
Electronics Forum | Tue Sep 14 04:16:55 EDT 2021 | mokshamanthra
Thanks DWL, we have a board with double sided SMT components now. and there is an intrusive component on the bottom side which is build first. the connector pin is extending out by 0.3mm and this is causing printing issues when building top side. we
Electronics Forum | Sat Oct 16 03:04:21 EDT 2021 | jessicasu
> Slanting Issues after reflow if u are using <BR> > thru-hole type, u might need to define the <BR> > slanting degree allowed during prototype. =) <BR> <BR> there is adding the insulating plastic will sol
Electronics Forum | Wed Sep 22 03:46:02 EDT 2021 | zxcvb
Hi all, I bought a PT2399 delay after reading a detailed introduction article about this device, here's the link:https://www.apogeeweb.net/circuitry/pt2399-delay-features-datasheet-application-circuit.html It says that BU9253 is the alternative of PT
Electronics Forum | Thu Nov 25 03:38:28 EST 2021 | ravikumargv
Hi, For above highlighted issues has been solved and now started "wrong embedded real time code version fatal error -reinitialse machine" what is the issues and where it went wrong please advise me to check further