Electronics Forum | Fri Aug 14 07:52:03 EDT 2015 | mun4o
Hi all, 2 weeks ago we installing a new P&P machine - chip shooter.But , after installation proved that vibration of the new P&P arе very strong.If I use mashine to 100% of the speed the machine vibrating and after 2-3 panels moving 3-5 mm.The machin
Electronics Forum | Wed Aug 19 09:14:26 EDT 2015 | sarason
Try a more intelligent telnet program that has a few diagnostics. I dont know the Mirae machine myself but the ext thing would be to do a trace on machine operation. maybe the booting sequence has the Telnet Host( Or is it Client?) boot after the mac
Electronics Forum | Wed Aug 19 09:05:03 EDT 2015 | scotceltic
Does anyone have a solution as follows: A scanner placed at the enterance of the screen printer, and a program created that can read a PCB's Barcode label. Send that barcode's program information to each piece of equipment (Paste Inspection and place
Electronics Forum | Tue Aug 25 07:48:41 EDT 2015 | derrikf
Both pictures are from .031" FR4. According to my MOLE it's actually staying above the liquidus temperature for close to too long. Datasheet says 90 secs, I'm in the high 80's. Not ruling it out as a possible cause, I suppose the data I'm getting c
Electronics Forum | Thu Aug 27 09:18:57 EDT 2015 | fcmtechnician
Hi Don't know your reflow brand, but try to decrease the blower speed...is possible that air blow out the componets! For vibration, chain related issue, etc open your hood and start the oven in colder recipe with pcb inside! ( put the service key o
Electronics Forum | Fri Aug 28 03:03:00 EDT 2015 | grimus
Thank you all for your advice. You are right this is two sides board, and dropped parts are on bottom side, and it is refered just to very light switches. I am using same temperature setup for top and bottom. What is interesting I am manufacturing t
Electronics Forum | Mon Jan 18 02:49:03 EST 2016 | nirmex
1-Machine speed. 2-New Head H24 and DYNA Head. 3-New Feeder type W08f 4-New Part Camera. 5-New Y-Axis Flat cable design. 6-New GUI with Touch Screen. 7-Panel Height detection. 8-Feeder raising detection. 9-NPI tools support. 10-Overall machi
Electronics Forum | Tue Sep 22 08:03:49 EDT 2015 | mervin
Hi. I have recently purchased a old MPM UP2000. I can not get it print correctly consistently. It goes off after 5 Pcb's and remain that amount off for another 5 Pcb's. Then it goes more off and remain like that for another 5 Pcb's. If you stop and e
Electronics Forum | Fri Oct 23 12:48:08 EDT 2015 | pjchonis
WE offer Kolb MultiEx N7, a broadband pH neutral cleaning solution that can be used in an ultrasonic cleaner (Concentrate dilution ratio of 1:6). The MultiEx N7 is rated for cleaning solder paste, flux, colophonium and suited for stencils, PCBs, and
Electronics Forum | Thu Oct 08 15:15:49 EDT 2015 | huske
BGA's are by far much easier to process correctly and inspect. As for LGA's you'll never get 100% of the materiel out from under it during the cleaning process. The voiding issue is magnified with and LGA, the low standoff is the reason for the v
