Electronics Forum | Sun Oct 16 22:53:08 EDT 2016 | a1
Hi, I have a FUJI CP4-3 machine that is experiencing issues with missing components. The machine keeps on running even after many parts are missing and it releases the board thinking it's complete. For an example, say there is 200 components to pla
Electronics Forum | Mon Oct 24 09:07:58 EDT 2016 | robl
Could you make up your own adaptor cable to connect to your programmer, then fit a small form connector like a Firewire on the edge of the PCB? It should only take up about 7x7mm of real estate as opposed to a 2.54mm 5x2 pin header 12.7 x 5.08, or a
Electronics Forum | Wed Nov 09 08:56:22 EST 2016 | sumote
The screens go in with some paste left on 'em, (operators can only remove so much manually) > That is BS. We clean our screens by hand ONLY and I am able to remove all of the solder using a 1" putty knife and Micro Care Alcohol-Enhanced Flux Rem
Electronics Forum | Sat Nov 19 03:26:08 EST 2016 | sarason
Have you tried running your image under a Virtual machine. From this you may be able to work out the requirements of the original machine, and so have some parameters to port the image forward on a faster PC, like say a pentium or Pentium III while s
Electronics Forum | Mon Nov 21 08:01:44 EST 2016 | edgard_franca
Hello everybody, The company that I work bought a second hand Phoenix X-Ray model PCBA 100. We installed the equipament and waited about 4 hours for warm the x-ray tube, after that time was generated the image. I turned off correctly the machine bu
Electronics Forum | Tue Jan 31 08:39:15 EST 2017 | chrism68
Dear Peter, I just bumped into your email, requesting for support. I know for a fact that this option needs a license I do not know exactly where you are based, but I do recommend you to contact our service hotline. They will be able to provide you
Electronics Forum | Thu Dec 08 01:44:44 EST 2016 | cmarasigan
We are currently experiencing with our SMD Solder Reflow Equipment on Shooting-Up Zones (Zones 3,4,5,7 & even Cooling Zone). PV exceeds about 5-10 degrees with the SP. (ex: SP=140deg, actual PV = 145deg & higher). Our equipment undergo a monthly prev
Electronics Forum | Mon Jan 23 08:06:52 EST 2017 | bukas
i have an issue with solder bath temperature. there is a big difference in temperature of alloy in the middle of the bath and at the ends(about 35C). i took down heating elements for inspection and they look fine. its just that most of the heat is cr
Electronics Forum | Sat Mar 11 08:37:35 EST 2017 | tch
My company has had the same issue on our Versaflow 366 with SAC305, we tried ultrasonic cleaning and it worked for a shift and then was clogged again. We have had the machine for 3 years and we have had to replace the gassing rings twice so far. We a
Electronics Forum | Mon Feb 13 08:32:41 EST 2017 | emeto
From what I have seen, people who really understand the standard, don't inspect boards on a daily basis. Boards are inspected by people, who don't know to fully apply the criteria of the IPC or other standard. The whole thing looks more like a show t