Electronics Forum | Mon Aug 16 05:09:30 EDT 1999 | Charles Stringer
Atlthough not strictly surface mount, I am sure that amongst the experienced players out there someone will have some answers for me. Does anyone have any experience of "phase change" heatsink materials. These are solid at room temperature and then t
Electronics Forum | Thu Aug 12 18:43:49 EDT 1999 | Wayne S.
Hello Having a problem with bridging on 20mil pitch qfp, only on the lead groups where squeegee goes over width of apertures. Using MPM sp-200 semi-auto, chem-etch stencil, 9-10mil width opening 100 durometer blade. Getting "tails" on deposits. Trie
Electronics Forum | Thu Aug 12 20:17:12 EDT 1999 | Kelly Morris
| Hello | | Having a problem with bridging on 20mil pitch qfp, only on the lead groups where squeegee goes over width of apertures. Using MPM sp-200 semi-auto, chem-etch stencil, 9-10mil width opening | 100 durometer blade. Getting "tails" on deposi
Electronics Forum | Thu Aug 12 17:07:09 EDT 1999 | Brian Wycoff
| Hello, | | Can any netters suggest what critical parameters should be considered & what are there assoicated impacts for a solder paste printing process ... | | B.Regards, | Felix | I have a process cause and effect diagram for the entire print
Electronics Forum | Fri Aug 13 00:05:12 EDT 1999 | Felix Mung
| | Hello, | | | | Can any netters suggest what critical parameters should be considered & what are there assoicated impacts for a solder paste printing process ... | | | | B.Regards, | | Felix | | | I have a process cause and effect diagram for
Electronics Forum | Thu Aug 12 00:17:15 EDT 1999 | DLKearns
Wanted to know if there was a good "to go by" tip other than the customers(if it helps current req.,10% of 30% of trace) requirements, about pits in the traces on copper plated ceramic substrates? More to the point how many is too many regardless of
Electronics Forum | Mon Aug 09 20:12:24 EDT 1999 | JohnW
Folk's, I'm looking for some helpful suggestions for reworking wave soldered bottomside components that have been glued. I'm not a fan of the twist and break approach and as some of them either have a double dot or a slot configuration this tend's t
Electronics Forum | Mon Aug 09 10:27:14 EDT 1999 | Tim Murphy
Just curious what effect pinholes and solder voids can have on solder joints that have high current passing thru them. Also could moisture from steam sterilization (autoclaving) get inside a said solder joint and then outgas during high current, and/
Electronics Forum | Mon Aug 09 04:15:33 EDT 1999 | Jacqueline Coia
I am having cleaning problems when processing PCB's which have TAIYO solder mask on them. After processing, hand soldering and cleaning, a sticky residue is remains, resulting in a cosmetically poor finish with tide marks etc. Other soldermasks do no
Electronics Forum | Sat Aug 07 03:35:38 EDT 1999 | JAX
| I am looking for a suppliers' of SMT Terminals on tape and reel to replace TH Terminals used on PCB assemblies. | Dimensions required are approx: | 0.093" high x 0.062" diam. Please contact me for further details. | | Thank you. JA/SR Telecom |