Electronics Forum | Tue Sep 01 10:55:41 EDT 2015 | emeto
Hi, 1. Take a multi meter and measure the voltage - I assume it is a DC motor(probably 24V). If you don't, check power supply,cable, relays and Driver for the motor. If you do have voltage, check sensors(sometimes sensor activated may stop your con
Electronics Forum | Tue Sep 01 17:44:46 EDT 2015 | abisson
Hello to All, Is someone can refer me to an IPC standard where the maximum allowance of pcb stretch is mention? I've look into IPC-600, or 2222 or 2615 and I cannot find what I'm looking for. I will like to implement a pass/fail incoming inspection
Electronics Forum | Thu Sep 17 10:18:54 EDT 2015 | huske
What model do you have? Are you working with a Midas only or Hydra as well? Are you looking for basic information on how to get started with chips and SO's? Or like how to use auto-teach or manually measuring parts and programming or more like select
Electronics Forum | Thu Sep 10 10:04:27 EDT 2015 | emeto
1. Automated optical inspection(this is a machine that checks for you using camera and software algorithms for recognition) 2. Electrical test. For any PCB a test device can be made. A standard one will look like this: Put the board in the device. Go
Electronics Forum | Fri Sep 11 17:02:10 EDT 2015 | adeanda74
Simon, Normally that error is caused by a bad motor but also there is a possibility that a driver board or even the servo board are defective and last but not least check all your cables and connections. finally let me mention that you can also recei
Electronics Forum | Fri Sep 18 05:10:07 EDT 2015 | bobpan
Hello Simon, I would check to make sure the covers are closed and the cover switches are working. Make sure an e-stop is not pressed. After that....I would check the contactors in the rear of the machine. I have had the contacts on the insides of som
Electronics Forum | Wed Sep 16 10:21:14 EDT 2015 | beta
Hi all, Is there much in the way of difference between a Fuji CP6 machine with the CE mark and a machine without the CE Mark? I know why the CE Mark is required within the EU but I am talking nuts & bolts here - is the machine any different? or is
Electronics Forum | Wed Sep 16 14:04:33 EDT 2015 | adventurelights
Hi guys, Recently got an error message when initiating hardware on a Mydata TP9-UFP. Message is: Theta/2: Lower end point not repeatable. Reinitiating fails at message. Haven't seen this message before. Any idea what it could be as production is hal
Electronics Forum | Tue Sep 22 14:23:42 EDT 2015 | travishemen
We had 4 of these machines several years ago. If I remember right the drive that aligns the board to the stencil was stepper motors with no encoder feedback. We would see the same issue if our leadscrews and linear rails were not clean and properly
Electronics Forum | Wed Sep 30 06:31:07 EDT 2015 | mervin
Thanks SWAG, I have checked the FP mode, I am aware of this. I have also worked on this machine some over 10 years ago but not as a service engineer. So I aware of the programming on the machine its just trouble shooting this particular machine is n
.gif)
