Electronics Forum | Tue Oct 09 05:38:29 EDT 2018 | dfl
Hi, my Quad IV-c is showing a really dark image on the camera and its VERY difficult to see the components pads to make the adjusts. I already check the monitor brightness (at maximum and I can see the crosshair, so the monitor is good) and already
Electronics Forum | Tue Oct 09 10:29:47 EDT 2018 | dfl
Thanks Bob. Using a flashlight helps a lot, indeed. Is "re-adjust the angle" just a bend on the LEDs heads (by hand)? I will try. To replace de LEDs, can I use white ones? I believe with the reds I get less light than whites, but maybe the camera ne
Electronics Forum | Fri Oct 26 09:43:19 EDT 2018 | dnachristen
Hello! A member here graciously sent me the pinout I needed. I now have 24v to the feeder in the test rig, but need to know what type of signal the feeder requires on pin 9 to electronically index. Anyone have a clue? I tried ground signal and 24v, n
Electronics Forum | Tue Oct 30 06:09:15 EDT 2018 | directx995
It's prob better to ask them which machines they use, since you have a few extenstion for only 1 machine manifacturer. Also, it may be a CAD file and you have A LOT of different CAD extensions, so I think it's better to make it clear with that EMS co
Electronics Forum | Wed Nov 13 09:26:10 EST 2019 | bobpan
I think it has something to do with the communication between the 2 computers. Plug a monitor into the back computer rack and see if there is an error showing when its trying to boot up. Its been a long time....so dont quote me....ha
Electronics Forum | Mon Nov 19 09:18:27 EST 2018 | reckless
Definitely helps! I came across this Yamaha newsletter mentioning 16 nozzles for YV-112 not 12 (see page 5). Are you sure Yamaha didn't sell different models to Assembleon? Did they change models alot? Also does the YSM40R really hit 200,000 cph
Electronics Forum | Mon Nov 26 09:33:49 EST 2018 | charliedci
The problem you create by soldering from solder destination side (presuming you have already soldered from other side) is that you will trap air in PTH so you have virtually no continuous solder in PTH from one side to other. This will not meet IPC-A
Electronics Forum | Thu Dec 06 09:24:10 EST 2018 | ameenullakhan
Hi Rob, We used different Reflow Oven and noticed the component drop is less 1 out of 24 components. But not able to analyze, why its falling more in other reflow oven. Our maintenance team is assuring there is no vibration in any of the oven. And
Electronics Forum | Thu Dec 06 09:39:33 EST 2018 | emeto
If you go this route vibration will not be your focus. there is something that is called pressure inside an oven. Some ovens have separate parameter to control that. Other will have the blower speed control. You should decrease the pressure(your conv
Electronics Forum | Sat Jan 05 09:34:10 EST 2019 | unisoft
5 minutes to program your assembly machine with the Unisoft ProntoPLACE software — http://www.unisoft-cim.com/pcbplace.htm --- contact us now & we will show you using your data or ours Use either CAD, Gerber or XY and BOM Save time on NPI, faster