Electronics Forum | Mon Sep 26 16:43:18 EDT 2011 | action_101
I am happy that you work in a shop that can build boards right the first time on a consistent basis. Unfortunately, I would say that every place I have been at, we have had a hard time meeting class III standards day in and day out without some kind
Electronics Forum | Thu Sep 29 17:42:49 EDT 2011 | action_101
I used Indium WF-9940 at the last place I was at for 5 years. We ran leaded and lead free product in our ERSAflow selective soldering machine with that flux type. It worked good for both applications. The place I am at now we have an Ersaflow selecti
Electronics Forum | Thu Sep 29 19:45:23 EDT 2011 | edwaterfall01
The conveyor is programmed to turn off the belts and go into an error condition after 30 seconds if the board has not passed the output sensor on the conveyor. The intent is to indicate a board jam and prevent damage to the board or belts. On convey
Electronics Forum | Thu Sep 29 18:48:19 EDT 2011 | jrsmachine
We have a Philips CSM84VZ which we acquired several years ago. It has been running fine until recently when a new employee ran it unsupervised. Since then, when in run mode, it wont't run, but just displays error code "#79:operation interrupted". our
Electronics Forum | Mon Oct 03 09:26:08 EDT 2011 | kahrpr
Hate to break it to you but 10k to 15k is becoming more common than you think. On the flip side companies biggest competition is becoming there own used equipment. Going out of bushiness because of slow sales is not very appealing either. Also in the
Electronics Forum | Wed Sep 19 12:27:56 EDT 2012 | proceng1
Are you sure that you are getting adequate nitrogen flow up through the cap? If your pump isn't seated properly, you may have nitrogen escaping. Also, I have two different height nitrogen bases. The shorter one does not allow as much gas to escape
Electronics Forum | Sun Oct 09 20:40:28 EDT 2011 | Jacki
Hi We found the misalignment sometime during SMT 0402chips. So, we made the pick up speed a bit slower then the condition was better however it was time-consuming and delay shipment. We r using Yamaha 100Xg SMT M/C and no probelm in mounting 0602 o
Electronics Forum | Sat Oct 22 09:02:46 EDT 2011 | mojomatt
Yes it is used for PCB, I have used it in the Automotive Service Industry for many uses. Most popular as a Brake assembly cleaning agent. It is popular today due to its low FLASH POINT, unlike other solvents that contain Heptane, Xylene etc thease ha
Electronics Forum | Tue Nov 01 09:54:42 EDT 2011 | emeto
Hi , I would think that when you added the new parts, you missed to give them some of the parameterrs and that's why you start to get error messages. Check part parameters(I don't know if you are talking about pick and place machine or some other mac
Electronics Forum | Tue Nov 01 09:36:41 EDT 2011 | emeto
THe question is - does that happen on all of your programs or just in one program? If it is just this particular board, it might be some softwaRE limit issue. If it happens on more programs it is a hardware issue and it could be one of the following:
.gif)
