Electronics Forum | Sat Sep 08 19:04:26 EDT 2012 | jlawson
You might also want to consider process repeatability cross profile performance over time and energy consumption. Also reliabilty is effected by shift usage etc,. Eg could have oven that might appear reliable in one context but not overall. Ie total
Electronics Forum | Fri Sep 07 11:31:54 EDT 2012 | aquinn
Hi I am using an old Camalot 1818 to dispense squares of epoxy on a substrate. Does anyone know if it is possible to do an array of squares across the entire substrate rather than individually entering the coordinates of each square? Thanks!
Electronics Forum | Fri Sep 07 16:37:47 EDT 2012 | burb1999
Ive used the Camalot long time ago to dispense paste on BGA pads after removal then reflow with a machine such as the AirVac. What is the best way to do BGA repair on pads? Ive read alot just reball the bga then put it back on? Todd
Electronics Forum | Wed Sep 12 10:49:46 EDT 2012 | cyber_wolf
Sounds like the feed cylinder sensor. Its a air cylinder hooked to the tape feeder advancing mechanism in the rear of the machine. Go into the I/O and make sure the sensor is changing state when you flag it.
Electronics Forum | Wed Sep 12 11:52:31 EDT 2012 | mtech88
Ben: you are right, I think the timing must be off some how. I will check the error code and post it back here. thanks David
Electronics Forum | Wed Sep 12 11:55:18 EDT 2012 | mtech88
Sr. Tech: I will check the air cylinder at the rear and see what position when the machine stop. Thanks David
Electronics Forum | Mon Sep 10 00:22:08 EDT 2012 | dws123
Many companies manufactures printed circuit boards but couldn't become successful. I want to buy these circuits but cannot get better boards yet suggest me about good printed circuit board assembly company.
Electronics Forum | Tue Oct 09 13:29:35 EDT 2012 | ericrr
Did I loose the plot at my last response? (October 04, 2012 10:22 AM") or was this to do pick & place assembly, NOT PCB panel manufacture.
Electronics Forum | Sun Sep 16 21:10:40 EDT 2012 | vikings
I did not desire the manuals to learn how to operate the machines, rather I wanted to know technical data such as the proper PSI for the air supply lines.
Electronics Forum | Thu Sep 13 04:49:30 EDT 2012 | hysmt
We are going to start a smt line, but I'm totally new in this line. Currently we have these two choices, any feedback is appreciated.