Electronics Forum | Mon Mar 23 16:38:09 EDT 2020 | emeto
Steve, On 16mil pitch I would try 12mil diameter on 5mil stencil, unless the BGA ball size is something unexpectedly huge.
Electronics Forum | Wed Mar 25 11:09:08 EDT 2020 | sumote
Have you measured and input the "Distance To Image" setting correctly? If that number is off, you will get that error.
Electronics Forum | Tue Mar 31 09:25:18 EDT 2020 | emeto
If you believe your picture is in the middle and is not skewed, than go to your basics and recheck your fiducial locations and detection. Sometimes these machines recognize something around and give you this error. Try program with isolated pads and
Electronics Forum | Fri Mar 20 09:29:27 EDT 2020 | slthomas
If you just want a little more paste and don't care where it ends up I guess percentage is OK, but if you're trying control where it ends up it makes sense to specify how far, and in which direction(s).
Electronics Forum | Thu Apr 02 09:49:10 EDT 2020 | stephendo
The problem is not with the software. The problem is with the data format. Gerber data is a photo plotting format. It essentially makes pictures. There is no way to make PnP programs easily from pictures.
Electronics Forum | Tue Mar 31 09:56:20 EDT 2020 | davef
On this page,... + Find the navbar, left margin, near the top of the page, comprised of blue-colored rectangles with white lettering + Scan down to the top third of the navbar + Click "Used SMT Equipment" + Select "Send RFQ" tab peach-colored, near c
Electronics Forum | Thu Apr 09 13:08:48 EDT 2020 | steveoky
I need a list of the on-line commands to communicate with the Topaz X remotely, I want to scan a barcode and send the correct program to the machine. Thank you
Electronics Forum | Sat May 09 00:03:52 EDT 2020 | compit
I don't know how in Germany, but in Poland it used to be 220V (380 for 3 phases), now it is 230V (400). Probably, after the change, no one switched the voltage to the trafo in the machine - these are old machines.
Electronics Forum | Mon May 04 09:18:18 EDT 2020 | ilavu
Also, Check jumpers on 9pin connectors at front, rear and both side. If anyone missing or broken, will do the same.
Electronics Forum | Wed May 06 09:24:07 EDT 2020 | tomazicrok3
hello does anyone know why i cant get out of freeze mode on samsung cp40cv machine when i press emerg. key. greetings