Electronics Forum: conveyor (Page 1 of 160)

Universal conveyor

Electronics Forum | Thu Apr 19 07:42:53 EDT 2012 | leemeyer

I just purchased a used Universal Instruments Boardflo conveyor model 5363. It looked like it would be perfect to connect 2 of my Quad 4c machines in line. it came with a SMPI to Smema converter box. I connected the box S1PL and S2PL to what I beleiv

board conveyor

Electronics Forum | Tue Oct 21 09:17:05 EDT 2003 | Bill

We are looking into a replacement conveyor and have come across 'smartmove' ---has anybody had any experience with their product? Bill

SMEMA conveyor

Electronics Forum | Wed Nov 02 12:49:59 EST 2005 | Olas

Thank you for the advice, Mika. My question however was not generated by a practical problem, but rather from the fact that we have to design an equipment which must interface with other conveyors. By now we�ll ignore those two points. Regards, Ola

Dynapace conveyor

Electronics Forum | Thu Apr 22 14:27:34 EDT 2010 | peteb

I have a Dynapace 400 series conveyor. How do I make it change direction? Is Dynapace still in business? Thanks for any info you may have.

SMEMA conveyor

Electronics Forum | Thu Oct 20 23:19:09 EDT 2005 | Cmiller

You should not be worried about these points in the SMEMA standard. You need to make it work for your application. If you are running really small boards, keep the gap between conveyors and the lead-in as tight as you can. If you are using large pane

SMEMA conveyor

Electronics Forum | Sun Oct 16 04:23:20 EDT 2005 | olas

I have a couple of questions about the SMEMA conveyor (standard 1.2); I posted the question to them but had no answer. SMEMA says: 5) Maximum gap. The maximum gap between the in-line machine track ends is 0.375� I would suppose this gap refers to th

Dynapace conveyor

Electronics Forum | Tue Apr 27 10:12:29 EDT 2010 | peteb

That's just what I did. Thanks for your reply.

SMEMA conveyor

Electronics Forum | Fri Oct 21 03:39:41 EDT 2005 | fastek

Exactly. Poor Olas is pulling his hair out over an issue that has no business being "standardized". The SMEMA guys with apparently way too much time on their hands couldn't simply stop at the communications protocol and leave it at that....they had t

SMEMA conveyor

Electronics Forum | Sat Oct 22 03:53:48 EDT 2005 | olas

Thank you guys, I wasn't really pulling my hair out, but I feel better after reading your point of view! Have a good day, Olas

Dynapace conveyor

Electronics Forum | Mon Apr 26 16:02:30 EDT 2010 | markhoch

Are the drive motors DC? Reverse polarity on the motors and switch your photosensors on the entry and exit end. You might have to play with the SMEMA connections a bit, but you'll figg it out. ;)

  1 2 3 4 5 6 7 8 9 10 Next

conveyor searches for Companies, Equipment, Machines, Suppliers & Information

SMT spare parts - Qinyi Electronics

Reflow Soldering 101 Training Course
best pcb reflow oven

Wave Soldering 101 Training Course
Win Source Online Electronic parts

Software for SMT placement & AOI - Free Download.
Circuit Board, PCB Assembly & electronics manufacturing service provider

Best Reflow Oven